HEMPEL

Specification sheet
Hempel (Denmark) A/S
Project:
Area:
SEPTIC TANK, ( EXCISTING TANK)
Remarks:
DANA - DOKNING 2010 Obj. ref.: 7912680
The surface must be completely clean and dry with a temperature 3°C/5°F above the dew point to avoid condensation.
Normal good painting practice must be followed throughout the entire painting procedure.
The specified high film thickness can best be obtained by airless spray application. If another application method is used more applications are necessary to achieve the specified dry
film thickness.
Stripe coating with brush is recommended on areas difficult to cover properly by spray as eg edges, corners, flanges, cutouts, handwelds and other rough surfaces.
Product information:
Mixing ratio Pot life Dry to touch Flash
Application restrictions
Shade no.
Volume
solids %
Curing
agent
volume
20°C 20°C
point
°C
VOC
g/ltr MAL Thinner
Min. Temp. Max. RH%
°C
HEMPINOL 10220 19990 57 16 h 38 340 08080 2-1
The data, specifications, directions and recommendations (hereinafter "Information") given in this painting specification are based upon test results obtained under controlled or specifically defined conditions and said Information is correct to the
best of our knowledge. The User must satisfy itself that it is appropriate to use the Product in accordance with the Information in the actual conditions under which the Product is intended to be used, and the Manufacturer and Seller do not
guarantee the accuracy, completeness or appropriateness of the Information when the Product is used in those conditions. The provisions of Clause 8 of the GENERAL CONDITIONS OF SALE, DELIVERY AND SERVICE shall apply to any and
all claims arising out of or in connection with the use of the Product as recommended above, overleaf or otherwise.
Hempel's PreSale System 2.6.16 (Build 673)
User name:
Henrik Berg
Quality Code: 34-11 / 0710
HEMPEL
Printed at: 21.07.2010 11:35 Department name: Sales Denmark Environment : Immersion
Created/Last modified: 21.07.2010 11:29 DKHEJ0181 Page: 12