GeoVision V8.5 Installation Guide - XTECHCAM

More documents

Recommendations

Info

98 4. Ensure to connect the GV-NET/IO Card to the 20-pin GV-NET/IO port on the GV- Combo A Card as illustrated below. The wrong connection may lead to the GV- NET/IO Card or the GV-Combo A Card to be damaged, causing Video Lost or an error message of “can’t find keypro” to pop up. 4 2 3 1 GV-NET/IO Card 1 O O O N N 1 1N2 GV-Combo A Card O N 20-Pin Ribbon Cable the Debug Port the GV-NET/IO Port
Connections with Two Video Capture Cards 2 Hardware Accessories If your system is equipped with two video capture cards, connect the GV-NET/IO Card to the video capture card of 1-16 channels. Connections in NET/IO Card Mode For the connections in the NET/IO Card Mode, please follow the instructions below: • It is required to connect the GV-NET/IO Card to GV-Video Capture Card with the 20- Pin Ribbon Cable. • If you want to connect the GV-NET/IO Card to RS-485 devices, you have three ways of connections. See below. Three Ways of Connections of GV-NET/IO Card and RS-485 Devices: 1. You can connect a RJ-11 to DB9 Cable to the PC's COM Port when a RS-485 device is connected. (Allowed for AC/DC Output Voltage) Figure 2-11 99
Page 1 and 2:
Before attempting to connect or ope
Page 3 and 4:
Contents Important Notice for V8.5.
Page 5 and 6:
Important Notice for V8.5 GPU Decod
Page 7 and 8:
Frame rate limit in a single hard d
Page 9 and 10:
Chapter 1 Video Capture Cards This
Page 11 and 12:
Connecting One GV-4008 Card • Con
Page 13 and 14:
Connecting Hardware Watchdog 1 Vide
Page 15 and 16:
Troubleshooting Power Supply Issues
Page 17 and 18:
1 Video Capture Cards 8. To access
Page 19 and 20:
1.2 GV-4008A 1 Video Capture Cards
Page 21 and 22:
Connecting Two GV-4008A Cards 1 Vid
Page 23 and 24:
Installing Drivers 1 Video Capture
Page 25 and 26:
1.3 GV-3008 1 Video Capture Cards T
Page 27 and 28:
Connecting Two GV-3008 Cards 1 Vide
Page 29 and 30:
Connecting Hardware Watchdog 1 Vide
Page 31 and 32:
Specifications Interface PCI-E x1 G
Page 33 and 34:
Packing List (D-Type) 1. GV-Combo A
Page 35 and 36:
Connecting One GV-Combo A Card (DVI
Page 37 and 38:
Connecting Two GV-Combo A Cards 1 V
Page 39 and 40:
Page 41 and 42:
Interface Type PCI-E x1 Input Type
Page 43 and 44:
Connecting One GV-1008 Card 1 Video
Page 45 and 46:
Figure 1-20 1 Video Capture Cards A
Page 47 and 48:
Page 49 and 50:
1.6 GV-900A 1 Video Capture Cards O
Page 51 and 52: Connecting Two GV-900A Cards 1 Vide
Page 53 and 54: Installing Drivers 1 Video Capture
Page 55 and 56: 1.7 GV-650A, GV-800A 1 Video Captur
Page 57 and 58: 1 Video Capture Cards For the BNC-t
Page 59 and 60: Connecting Hardware Watchdog 1 Vide
Page 61 and 62: Specifications Interface PCI, PCI-E
Page 63 and 64: 1.8 GV-600A 1 Video Capture Cards T
Page 65 and 66: 1 Video Capture Cards For the BNC-T
Page 69 and 70: Specifications Interface PCI Input
Page 71 and 72: Packing List 1. GV-600B, GV-650B or
Page 75 and 76: Specifications Interface PCI, PCI-E
Page 77 and 78: 1.10 Installing Two Cards 1 Video C
Page 79 and 80: 1.11 Installing Drivers 1 Video Cap
Page 81 and 82: 1 Video Capture Cards GV-4008 GV-40
Page 83 and 84: 1 Video Capture Cards 1.13 Comparis
Page 85 and 86: 1 Video Capture Cards GV-1008 GV-11
Page 87 and 88: 1 Video Capture Cards GV-600B x 2 G
Page 89 and 90: Chapter 2 Hardware Accessories This
Page 91 and 92: Connections 2 Hardware Accessories
Page 93 and 94: Installing Drivers 2 Hardware Acces
Page 97 and 98: 2.3 GV-NET Card V3.1 2 Hardware Acc
Page 99 and 100: 2 Hardware Accessories 3. You can c
Page 101: Overview Relay Out 1 Relay Out 2 Re
Page 105 and 106: Connections In I/O Box Mode 2 Hardw
Page 107 and 108: Switching Modes 2 Hardware Accessor
Page 109 and 110: Specifications OS Supported Input O
Page 111 and 112: Connections Following provides two
Page 113 and 114: Specifications OS Supported Serial
Page 115 and 116: Extending Transmission over the Dis
Page 117 and 118: 2.7 GV-I/O 12-In Card V3 2 Hardware
Page 119 and 120: Note: 2 Hardware Accessories 1. Use
Page 123 and 124: 2.9 GV-I/O Box (16 Ports) 2 Hardwar
Page 125 and 126: Connections to PC There are three w
Page 129 and 130: Specifications Input Output Input 1
Page 131 and 132: Overview DIP Switch Figure 2-37 2 H
Page 133 and 134: Assigning Addresses to GV-I/O Box 8
Page 135 and 136: 2 Hardware Accessories 3. Multiple
Page 137 and 138: 2.11 GV-I/O Box (4 Ports) 2 Hardwar
Page 139 and 140: Connections to PC There are two way
Page 143 and 144: 2 Hardware Accessories 2.12 Accessi
Page 145 and 146: 2.12.2 DHCP Connection 2 Hardware A
Page 147 and 148: 2.12.2.2 Configuring GV-I/O Box on
Page 149 and 150: 2.12.4 Input Setting In the left me
Page 151 and 152: 2.12.6 In/Out Monitor In the left m
Page 153 and 154:
2.12.8 Changing Login ID and Passwo
Page 155 and 156:
Chapter 3 Software Installation Thi
Page 157 and 158:
3.2 Installing the System 3 Softwar
Page 159 and 160:
3.3 Program List The Surveillance S
Page 161 and 162:
Chapter 4 Screen Overview This chap
Page 163 and 164:
The controls in the main screen: No
Page 165 and 166:
The controls in the ViewLog window:
Page 167 and 168:
4.3 SingleView Viewer 16 15 14 13 1
Page 169 and 170:
The controls in the MultiView Viewe
Page 171 and 172:
The controls in the Center V2 windo
Page 173 and 174:
Troubleshooting
Page 175 and 176:
Troubleshooting A message “Can’
show all

GeoVision V8.5 Installation Guide - XTECHCAM

Create successful ePaper yourself

Delete template?

Save as template?