GeoVision V8.5 Installation Guide - XTECHCAM

More documents

Recommendations

Info

Connections with Two Video Capture Cards In the computer where two video capture cards are installed, the GV-Multi Quad Card should connect to only one video capture card. Use the supplied Ribbon Cable to connect the GV- Multi Quad Card to the video capture card of your choice. 88 Figure 2-2
Installing Drivers 2 Hardware Accessories After you install the GV-Multi Quad Card to the computer, the Hardware Wizard will automatically detect the device. Ignore the wizard, and follow the steps in 1.8 Installing Drivers to install drivers. To verify the drivers are installed correctly, go to Device Manager. Expanding the Sound, video and game controllers field, you should see the entries for GVTVOUT Audio #A and GVTVOUT Video Capture #A. Specifications Interface for GV-Video Capture Card Figure 2-3 Verifying GV-Multi Quad Card drivers 40-Pin Connector TV Output DB15 to 5 BNC Connectors Input Signal 16 Channels TV Monitor Layout Port 1: supports up to 16 screen divisions. Port 2 ~ Port 5: support 1 and 4 screen divisions. Compatible Model All GV-Video Capture Card models Dimensions (W x H) 178 x 104 mm / 7.01 x 4.09 in Ordering Information 55-TVOUT-050 89
Page 1 and 2:
Before attempting to connect or ope
Page 3 and 4:
Contents Important Notice for V8.5.
Page 5 and 6:
Important Notice for V8.5 GPU Decod
Page 7 and 8:
Frame rate limit in a single hard d
Page 9 and 10:
Chapter 1 Video Capture Cards This
Page 11 and 12:
Connecting One GV-4008 Card • Con
Page 13 and 14:
Connecting Hardware Watchdog 1 Vide
Page 15 and 16:
Troubleshooting Power Supply Issues
Page 17 and 18:
1 Video Capture Cards 8. To access
Page 19 and 20:
1.2 GV-4008A 1 Video Capture Cards
Page 21 and 22:
Connecting Two GV-4008A Cards 1 Vid
Page 23 and 24:
Installing Drivers 1 Video Capture
Page 25 and 26:
1.3 GV-3008 1 Video Capture Cards T
Page 27 and 28:
Connecting Two GV-3008 Cards 1 Vide
Page 29 and 30:
Connecting Hardware Watchdog 1 Vide
Page 31 and 32:
Specifications Interface PCI-E x1 G
Page 33 and 34:
Packing List (D-Type) 1. GV-Combo A
Page 35 and 36:
Connecting One GV-Combo A Card (DVI
Page 37 and 38:
Connecting Two GV-Combo A Cards 1 V
Page 39 and 40:
Installing Drivers 1 Video Capture
Page 41 and 42: Interface Type PCI-E x1 Input Type
Page 43 and 44: Connecting One GV-1008 Card 1 Video
Page 45 and 46: Figure 1-20 1 Video Capture Cards A
Page 47 and 48: Installing Drivers 1 Video Capture
Page 49 and 50: 1.6 GV-900A 1 Video Capture Cards O
Page 51 and 52: Connecting Two GV-900A Cards 1 Vide
Page 53 and 54: Installing Drivers 1 Video Capture
Page 55 and 56: 1.7 GV-650A, GV-800A 1 Video Captur
Page 57 and 58: 1 Video Capture Cards For the BNC-t
Page 59 and 60: Connecting Hardware Watchdog 1 Vide
Page 61 and 62: Specifications Interface PCI, PCI-E
Page 63 and 64: 1.8 GV-600A 1 Video Capture Cards T
Page 65 and 66: 1 Video Capture Cards For the BNC-T
Page 69 and 70: Specifications Interface PCI Input
Page 71 and 72: Packing List 1. GV-600B, GV-650B or
Page 75 and 76: Specifications Interface PCI, PCI-E
Page 77 and 78: 1.10 Installing Two Cards 1 Video C
Page 79 and 80: 1.11 Installing Drivers 1 Video Cap
Page 81 and 82: 1 Video Capture Cards GV-4008 GV-40
Page 83 and 84: 1 Video Capture Cards 1.13 Comparis
Page 85 and 86: 1 Video Capture Cards GV-1008 GV-11
Page 87 and 88: 1 Video Capture Cards GV-600B x 2 G
Page 89 and 90: Chapter 2 Hardware Accessories This
Page 91: Connections 2 Hardware Accessories
Page 95 and 96: Connections 2 Hardware Accessories
Page 97 and 98: 2.3 GV-NET Card V3.1 2 Hardware Acc
Page 99 and 100: 2 Hardware Accessories 3. You can c
Page 101 and 102: Overview Relay Out 1 Relay Out 2 Re
Page 103 and 104: Connections with Two Video Capture
Page 105 and 106: Connections In I/O Box Mode 2 Hardw
Page 107 and 108: Switching Modes 2 Hardware Accessor
Page 109 and 110: Specifications OS Supported Input O
Page 111 and 112: Connections Following provides two
Page 113 and 114: Specifications OS Supported Serial
Page 115 and 116: Extending Transmission over the Dis
Page 117 and 118: 2.7 GV-I/O 12-In Card V3 2 Hardware
Page 119 and 120: Note: 2 Hardware Accessories 1. Use
Page 121 and 122: Connections 2 Hardware Accessories
Page 123 and 124: 2.9 GV-I/O Box (16 Ports) 2 Hardwar
Page 125 and 126: Connections to PC There are three w
Page 129 and 130: Specifications Input Output Input 1
Page 131 and 132: Overview DIP Switch Figure 2-37 2 H
Page 133 and 134: Assigning Addresses to GV-I/O Box 8
Page 135 and 136: 2 Hardware Accessories 3. Multiple
Page 137 and 138: 2.11 GV-I/O Box (4 Ports) 2 Hardwar
Page 139 and 140: Connections to PC There are two way
Page 143 and 144:
2 Hardware Accessories 2.12 Accessi
Page 145 and 146:
2.12.2 DHCP Connection 2 Hardware A
Page 147 and 148:
2.12.2.2 Configuring GV-I/O Box on
Page 149 and 150:
2.12.4 Input Setting In the left me
Page 151 and 152:
2.12.6 In/Out Monitor In the left m
Page 153 and 154:
2.12.8 Changing Login ID and Passwo
Page 155 and 156:
Chapter 3 Software Installation Thi
Page 157 and 158:
3.2 Installing the System 3 Softwar
Page 159 and 160:
3.3 Program List The Surveillance S
Page 161 and 162:
Chapter 4 Screen Overview This chap
Page 163 and 164:
The controls in the main screen: No
Page 165 and 166:
The controls in the ViewLog window:
Page 167 and 168:
4.3 SingleView Viewer 16 15 14 13 1
Page 169 and 170:
The controls in the MultiView Viewe
Page 171 and 172:
The controls in the Center V2 windo
Page 173 and 174:
Troubleshooting
Page 175 and 176:
Troubleshooting A message “Can’
show all

GeoVision V8.5 Installation Guide - XTECHCAM

Create successful ePaper yourself

Delete template?

Save as template?