Manual - Surveillance System, Security Cameras, and CCTV ...

Output Module: Triggers the specified output module when the input is activated. Use the
drop-down lists to select the output module
and pin number to perform this function.
Right Arrow button: Sets the time to delay the activation of the specified output module.
Register Input Event: This option logs the alarm events into System Log. Each event
is labeled
with ID, time, device name (camera or I/O input), corresponding module of the device, and event
for later retrieval. For details on System Log, see System Log in Chapter 1.
Note: The Delay Time in Invoke to Send Alerts and Output Module allow you time
to turn off the
input
device before the system triggers alerts or the output device. The Delay Time will not work if you
stop monitoring or enable the function “Deactivate notification when selected pin ON" in I/O
Application window (Figure 6-8).
[Output X] Click the Arrow buttons to select an output.
Apply to all Outputs
Select Output
Keep Last Toggle Status
Figure 6-3
Name: Specifies a name for the output device in the Name field.
Force Output: Click to test signal to the selected device.
Signal Type: There are six signal types available: N/O (Normal Open),
N/O Toggle, N/O Pulse,
N/C (Normal Closed), N/C Toggle, and N/C Pulse. Choose the
one that mostly suits the device
you’re using. For Toggle output type, the output continues to be triggered until a new input trigger
ends the output. For Pulse output type, the output is triggered for the amount of time you specify
in Sec field.
Keep Last Toggle Status: See Keeping Last Toggle Status later in this chapter.
Note: PTZ camera and I/O devices cannot be assigned to the same port at the same time.
6
I /O Applications
295