FL900 Series Flow Logger - Hachflow

More documents

Recommendations

Info

Figure 3 Battery cover removal 1 2 10 English
3 Attach an external power supply (optional) W A R N I N G Potential explosion hazard. The instrument is not approved for use in hazardous locations. The instrument can be powered by an external long-life battery, an SD900 power supply or other source that can supply power in the specified range (refer to Specifications on page 3 and Replacement parts and accessories on page 26). If the logger has both external power and internal batteries, the internal batteries are used as an auxiliary power supply. When the external power falls below approximately 9 V, the internal batteries supply power until the voltage from the external source is above 9 V. 1. Install the external power source in a safe location near the logger. Be sure to obey all safety precautions for the power supply. 2. Attach the cable from the power source to the AUX connector on the logger (Figure 4). 3. Apply power to the power source, if applicable. English 11
Page 1 and 2: DOC026.97.80015 FL900 Series Flow L
Page 3 and 4: Table of contents Specifications on
Page 5 and 6: Use of hazard information D A N G E
Page 7 and 8: Country-specific approval for Wi-Fi
Page 9: Figure 2 Connectors—side 2 1 Sens
Page 13 and 14: 1. Find the link for the FL900 Seri
Page 15 and 16: sensors. Connect the auxiliary cabl
Page 17 and 18: 1 2 3 4 English 17
Page 19 and 20: Figure 11 Serial number location N
Page 21 and 22: Figure 12 Call the server 1 Call in
Page 23 and 24: . Select the interval from the drop
Page 25 and 26: Replace the batteries Replace the b
Page 27 and 28: Table des matières Caractéristiqu
Page 29 and 30: Veuillez lire l'ensemble du manuel
Page 31 and 32: 1. Débrancher l'équipement de la
Page 33 and 34: Figure 1 Connecteurs : côté 1 1 C
Page 35 and 36: 1 2 3 Français 35
Page 37 and 38: Figure 5 Câbles d'alimentation à
Page 39 and 40: Figure 7 Raccordement d'un capteur
Page 41 and 42: Conditions préablables : assurez-v
Page 43 and 44: Configuration d'un compte GPRS bas
Page 45 and 46: 3. Cliquez sur Communications (Comm
Page 47 and 48: Création d'un programme de base po
Page 49 and 50: Suspension à un câble A V I S N'u
Page 51 and 52: • Réglez l'antenne pour augmente
Page 53 and 54: Especificación Alarmas Acciones de
Page 55 and 56: Precauciones para espacios confinad
Page 57 and 58: Módem MTSMC-C1-GP (CDMA): • FCC:
Page 59 and 60: Conexión de una fuente de alimenta
Page 61 and 62:
Conexión de una fuente de alimenta
Page 63 and 64:
entre el sensor y el registrador. F
Page 65 and 66:
Figura 8 Interfaz del usuario 1 Ins
Page 67 and 68:
1 2 3 4 Español 67
Page 69 and 70:
Figura 11 Ubicación del número de
Page 71 and 72:
Figura 12 Llamada al servidor 1 Obj
Page 73 and 74:
5. Para establecer el intervalo de
Page 75 and 76:
Figura 13 Registrador colgado de un
Page 77 and 78:
• Si no se resuelve el problema,
Page 79 and 80:
Especificação Intervalos de regis
Page 81 and 82:
Definição de um espaço confinado
Page 83 and 84:
Opinião: compatível de acordo com
Page 85 and 86:
Alterações na temperatura e press
Page 87 and 88:
Figura 4 Opções de energia extern
Page 89 and 90:
Figura 6 Anexar um sensor ao logger
Page 91 and 92:
Quando o logger possui um modem, os
Page 93 and 94:
Configure uma conta baseada em mode
Page 95 and 96:
Opção GPRS Intervalo de chamada p
Page 97 and 98:
Fazer um programa básico de logger
Page 99 and 100:
O logger pode ser pendurado a parti
Page 101:
• Caso não seja possível soluci
show all

FL900 Series Flow Logger - Hachflow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?