SABO 7 SABO 72-12G - SABO 72-12H - Operator's Manual

TROUBLESHOOTING
PROBLEM SITUATION LIKELY CAUSE SOLUTIONS
5. Weak engine
performance during
cutting
6. The engine
stops but the
light flashes
7. The engine
stops and the
light goes off
8. The engine
stops but the
light stays on
9. Uneven cut
and poor grass
collection
Key in «ON»,
engine running
Key in «ON»,
engine running
Key in «ON»,
engine running
Key in «ON»,
engine running
Key in «ON»,
engine running
– forward speed too high in relation
to cutting height
– the safety devices cut in
Electronic card in safety alert, due
to:
– earthed micro-switches
– flat battery
– overload caused by the charge
regulator
– badly connected battery (poor
contact)
– engine badly earthed
– problems in the engine
– cutting deck not parallel to the
ground
– blade cutting badly
– forward speed too high compared
to height of grass
– collector channel is obstructed
– cutting deck full of grass
ENG 41
– reduce the forward speed
and/or raise the cutting
deck
– check that the conditions
allowing starting are met
(see page 26/b)
Put the key in the «OFF»
position and look for the
cause of the problem:
– check connections
– recharge battery
– consult your Dealer
– check battery connections
– check engine earth connection
– consult your Dealer
– check tyre pressures
– re-align the cutting deck to
the ground
– check that the blade is fitted
properly
– sharpen or replace the
blade
– check the tension of the
belt
– reduce forward speed
and/or raise the cutting
deck
– wait for grass to dry
– remove the grass-catcher
and empty the collector
channel
– clean the cutting deck