Trumatic E 4000 / E 4000 A - Ostsee Campingpartner
Trumatic E 4000 / E 4000 A - Ostsee Campingpartner
Trumatic E 4000 / E 4000 A - Ostsee Campingpartner
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Gas connection<br />
The gas supply’s operating pressure (30 mbar) must<br />
be the same as the unit’s operating pressure (see type<br />
plate).<br />
The 8 mm diameter gas supply pipe must be attached to the<br />
connecting piece with a cutting ring connection. Carefully<br />
counterhold with another spanner when tightening!<br />
The gas connecti on fitting on the appliance is not to be shortened<br />
or bent.<br />
Prior to connecting the appliance make sure that the gas lines<br />
are free from dirt, chips and such!<br />
Choose to route the pipes in a way that will facilitate removing<br />
the unit for service tasks.<br />
Keep the number of parting connections in the gas supply<br />
line in rooms frequented by people to a technically feasible<br />
minimum.<br />
The gas system must accord with the technical and administrative<br />
provisions of the individual country of use (in Europe,<br />
for example, EN 1949 for motor vehicles or EN ISO 10239 for<br />
boats). National regulations and rulings (in Germany, for example,<br />
the DVGW worksheet G 607 for motor vehicles or G 608<br />
for boats) must be respected.<br />
Function check<br />
After installation, the gas feed line must be tested for tightness<br />
by the pressure-drop method. A test certificate (in Germany,<br />
for example, in accordance with DVGW Worksheet<br />
G 607 for motor vehicles or G 608 for boats) is to be issued.<br />
All equipment functions must be tested in accordance with<br />
the user manual after installation.<br />
The operating instructions and completed guarantee card are<br />
to be given to the owner of the vehicle.<br />
Remove the type plate from the operating and installation<br />
instructions and affix it at a position on the heater<br />
which is clearly visible and well protected against damage.<br />
The year of initial operation must be marked on the type plate.<br />
Warning information<br />
The installer or vehicle owner must apply the yellow sticker<br />
with the warning information, which is enclosed with the appliance,<br />
to a place in the vehicle where it is clearly visible to<br />
all users (e.g. on the wardrobe door)! Ask Truma to send you<br />
stickers, if necessary.<br />
24