CLIMAZON2 - Wella

ENGLISH
9 Errors and possible rectification
You can perform the rectification measures listed below yourself, making sure
you follow the safety instructions.
The following appears in the display f:
:
Errorcode 10 1. Error in temperature mea-suring circuit.
it.
Switch off appliance and attach a FAULTY sign to
Contact Wella Customer Service.
Errorcode 21 ... 25 2. Heating circuit interrupted.
Errorcode 31 ... 38 3. Fault in internal power
supply
Errorcode 39 4. Internal communication
error
➥ Switch off appliance and attach a FAULTY sign to
it.
Contact Wella Customer Service.
➥ Switch off appliance and attach a FAULTY sign to
it.
Contact Wella Customer Service.
➥ Switch off appliance and attach a FAULTY sign to
it.
Contact Wella Customer Service.
Errorcode 40 ... 49 5. Internal data error ➥ Switch off appliance and attach a FAULTY sign to
it.
Contact Wella Customer Service.
Errorcode 30
The following appears in the display f:
:
Heating cannot be switched
off.
➥ Switch off appliance immediately.
Remove plug b.
➥ Attach a FAULTY sign to the appliance.
Contact Wella Customer Service.
Protection filter soiled
Treatment temperature is too low:
Protection filter in front of ➥ Replace protection filter as described in “section
the temperature sensor 3 is 8.2” page 75.
soiled.
Position of the side arms
:
The side arms are in the
wrong position for the
selected treatment.
➥ Turn the side arms in the direction of the arrow
shown in the display f.
Position of the heating elements
:
The heating elements 1 are ➥ Turn the heating elements 1 in the direction of
in the wrong position for the the arrow shown in the display f.
selected treatment.
Should further errors or malfunctions occur or the rectification measures listed
fail to eliminate the error, write down the error messages displayed and contact
the Wella Customer Service Centre.
For your own safety, do not try to correct other problems yourself!
76