Reference Guide

Manually Triggering a URL Trace
Zend Server Reference Manual
This procedure describes how to manually run a code tracing on a specific URL. Running a code trace on
a specific URL will capture the current activity at the time the trace was triggered.
To manually trigger code tracing on a specific URL:
1. Go to Monitor | Code Tracing.
2. Enter the URL/IP in into the "Trace URL field and click
The URL has to be running on the Server running Zend Server.
The trace information will be collected and added to the list in the Code Tracing page.
Running Code Tracing on Another Machine
You can run Code Tracing on another machine as long as the Zend Code Trace component is installed
and running on it. However, when running a trace on a remote machine the trace information is collected
on that machine therefore, Instead of running the trace from a remote machine always run a trace on the
specific machine you need. If you do want to run a trace on a remote server after all, make sure that the
server's IP is an allowed host in Server Setup | Debugger.
129