Reference Guide

Zend Server Reference Manual
440
And change the following values:
activityTimeout=""
requestTimeout=""
PHP Settings
This procedure describes how to configure your PHP's execution time.
To configure your PHP's execution time:
1. In Zend Server go to Server Setup | Directives
2. Edit the value of the following directives:
3. Change max_execution_time to and max_input_time
to
4. Restart PHP
Scripts that run more than 30 seconds but less than should now run. See below
for instructions on how to test this.
Testing the Changes
The following procedure shows how to run a short script that checks if the settings have been properly
applied.
To test your settings:
1. Open a text editor and insert the following code:
2. Run the script from your docroot, if the script suceeded to run you will see the following
message in your browser "If you see this text the script completed and the defaults were
changed"
If the test failed you will not see a message in your browser. In that case try restarting your webserver
and running the script again.