MECABLITZ 50 AF-1 digital - Materiel.net
MECABLITZ 50 AF-1 digital - Materiel.net
MECABLITZ 50 AF-1 digital - Materiel.net
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Setting of the remote channel<br />
☞ The same remote channel must be set on the slave flash unit as on the<br />
master or controller flash unit!<br />
• With the remote slave mode activated,<br />
CH 2<br />
CH 2 press the button combination „Select“ until<br />
„CH“ (= remote channel) flashes in the<br />
display.<br />
• Apply the setting desired with the buttons<br />
+ and —. Selection of group 1, 2, 3 or 4<br />
is possible.<br />
The setting takes effect immediately. After about 5 seconds the display stops<br />
flashing and the setting is saved automatically. After activation of the remote<br />
slave mode, „ SL “ appears in the display. In addition, the slave group (GROUP)<br />
selected and the remote channel (CH) are shown.<br />
Testing remote flash mode<br />
• Place the slave flash units in the desired positions for the shot. Use flash unit mounting<br />
foot S60 (optional accessories, see 17) to set up the slave flash unit.<br />
• Wait for all of the flash units involved to become flash ready. Once the slave<br />
flash units are flash ready, the <strong>AF</strong> measuring beam � will blink.<br />
• Press the manual firing button � on the master or controller flash unit to fire a<br />
test flash. The slave flash units will respond in succession, according to slave<br />
group, with a test flash. If a slave unit fails to fire a test flash, check the settings<br />
for remote channel and slave group. Correct the position of the slave<br />
flash unit so that it is able to receive light from the master flash unit.<br />
☞ The flash mode is transmitted automatically by master or controller.<br />
When the flash unit functions as master in the cordless remote system,<br />
the activation of the modelling light also activates the modelling light of<br />
slave flash units<br />
☛ ☛<br />
9.2.2 SERVO mode<br />
Servo mode is a simple slave mode in which the slave flash unit always triggers<br />
a flash as soon as it receives a light pulse.<br />
Adjustment procedure for servo flash mode<br />
• Set a mode for the camera flash unit without preflash.<br />
• Press the "Select" button repeatedly until SL<br />
SL<br />
SL blinks on the display.<br />
On<br />
• Press the + button to activate remote slave mode.<br />
• Press the + button again and activate servo mode.<br />
In servo mode, only manual flash mode is possible.<br />
Manual flash mode M is automatically<br />
activated after switching to servo mode. SERVO<br />
• Partial lighting levels can be set with the + and - buttons.<br />
• Wait for the flash-readiness of all connected flash units.<br />
Once the slave flash unit is ready, its <strong>AF</strong> measuring beam � will start blinking.<br />
Slave groups and remote channels can not be set in SERVO mode.<br />
☞<br />
Turn off SERVO flash mode<br />
• Press the button sequence repeatedly until<br />
SERVO blinks on the display.<br />
• Press the – button twice to turn the SERVO<br />
mode off.<br />
☛ ☛<br />
M<br />
SERVO P 1/1<br />
Zoom 24 mm<br />
☛<br />
SL<br />
OFF<br />
☛ OFF<br />
103<br />
�