MECABLITZ 50 AF-1 digital - Materiel.net

3D multi-sensor fill-in flash mode
Matrix-controlled fill-in flash mode
This analogue TTL flash mode is supported by cameras from Group C (see Table This analogue TTL flash mode is supported by cameras from Group B (see Table
1). Prior to shooting, the flash unit fires a series of barely visible measuring pre- 1). The subject and background lighting is automatically adjusted to each other
flashes. The TTL multi-sensor and the micro-controller of the camera evaluate the without the subject itself being overexposed. The lighting setting for the ambient
reflected preflash light so that the subsequent TTL flash exposure is optimally light is determined by the camera with matrix measurement.
adapted to the prevailing photographic situation („multi-sensor fill-in flash“). When used with cameras from Group A (see Table 1), the setting and display of
If lenses are used that transmit distance data to the camera (for example, this fill-in flash mode occurs in the camera itself or this flash mode is automati-
„D-AF Nikkor lens“), this data is taken into consideration in addition in adjucally activated by the camera itself (see camera’s operating instructions). In this
sting the flash exposure („3D multi-sensor fill-in flash“).
case there is no setting and display in the flash unit.
Setting procedure
Setting procedure
TTLBL
7,5 m
TTLBL
F 5,6
Zoom 105 mm
• Press „Mode“ � button until „ TTLBL“
flashes in the display.
The setting takes effect immediately.
• Press „Mode“ � until „ TTL BL“ flashes in
the display.
The setting takes effect immediately.
TTLBL
7,5 m
TTLBL
F 5,6
Zoom 105 mm
After about 5 seconds the display stops
After about 5 seconds the display stops flashing and
the setting is saved automatically.
flashing and the setting is saved automatically.
„ TTL BL“ appears in the display.
„ TTL BL“ appears in the display.
☞ Some cameras do not support the 3D multi-sensor fill-in flash in combination
with SPOT exposure metering! This flash mode (symbol „BL“) will
then either be automatically cancelled or cannot be activated in the first
place! In these cases, the normal TTL flash mode will be set.
☞ Some cameras do not support the matrix-controlled fill-in flash mode in
combination with SPOT exposure metering! This flash mode ( „ TTL BL“)
will then either be automatically cancelled or cannot be activated in the
first place! In these cases, the normal TTL flash mode will be set.
☛
☛
97
�