manuale d'uso operation manual manuel d'instructions - Campagnolo
manuale d'uso operation manual manuel d'instructions - Campagnolo
manuale d'uso operation manual manuel d'instructions - Campagnolo
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
UK - 13<br />
Self Learning Feature<br />
When CDC sensor is attached to your bike, the ErgoBrain automatically<br />
calculates the number of teeth of your sprockets. (This is why you did not<br />
have to input the sprockets' teeth in Page 6.) This is called Self Learning<br />
feature.<br />
Even when the wheel is changed during a race, you only need to do the<br />
updating <strong>operation</strong> (as the explanation below) and the unit continues selflearning<br />
without loss of any data.<br />
You also need to do the updating <strong>operation</strong> when you have changed the<br />
sprockets (cog set).<br />
Updating *<br />
Danger !<br />
• When riding, always remain aware of your surroundings. Do not<br />
give excessive attention to the data displayed. Maintain your focus<br />
on the road, traffic conditions, obstacles, etc.<br />
Updating should be done while riding your bicycle. You can start the updating<br />
with any chain position, but be sure that chain is not skidding but in secure<br />
position and the crank is rotating firmly. In any measuring modes, hold down<br />
S/S button for more than two seconds, and the unit starts updating.<br />
Starts updating<br />
2sec.<br />
S/S<br />
Updating<br />
Note: The unit takes about five seconds, depending on the riding speed,<br />
to calculate the number of teeth of each sprocket. While calculating,<br />
the wheel icon flashes.<br />
Immediately after starting the updating process, the unit might show incorrect<br />
teeth numbers, but the system will be instantaneously calibrated<br />
and recalculated to the correct numbers.<br />
* If CDC sensor is not attached, the self learning feature does not work.<br />
Other Information<br />
• When the main unit is detached from the bracket, the data related to<br />
chainrings/sprockets will disappear.<br />
• If SET button is held down for about three seconds in the TM function of<br />
Auto Timer screen, the unit automatically falls into sleep state.<br />
ENGLISH