Multilingual Version English Français Español 日本語 Deutsch ...

MAIN MENU5.4.8 DCCSNote: This function is for selected models only.Note: DCCS is supported only for CH1. Make sure you’ve connected a DCCS-enabled camera to thevideo channel of CH1, and you see “ ” in the channel status bar.ADVANCED CONFIGCAMERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 DETECTION DIAGNOSTIC STARTALERT MENU SETUPNETWORKDISPLAYRECORDDEVICES DEVICE AVK523DCCS CONNECTION OKIVSNOTIFYEXIT1) DIAGNOSTICClick “START” to start examining the DCCS signal transmission between the DVR and the camera. Theresult will display in “CONNECTION”.2) MENUClick “SETUP” to configure the connected zoom lens control camera.Different zoom lens control cameras might have different parameter settings. For details, please refer to theirown user manuals.Note: While configuring the camera parameters, the DVR will switch to the corresponding channel, andyou can simultaneously preview the effects for the settings.3) DEVICEHere shows the model number of the camera.4) CONNECTIONHere shows the examining result for DCCS signal transmission between the DVR and camera. Themessage is as follows:MESSAGE SHOWNCHECKINGOKFAILMEANINGThe DVR is checking the DCCS signal transmission between the DVR and camera.The signal transmission is fine and the DCCS function works properly.The signal transmission is too weak or not available for the DCCS function to work properly.37