Aggregati Aggregates Aggregate Agrégats Agregados - HSD

GB
3 Tool characteristics
3.2 Milling tools
The milling tools are fixed using a spindle fitted with a collet and
lock ring. The diameter and length of the shank will vary according
to the type of collet fitted to the spindle.
In the case of an ER 16 collet mounting, it is possible to use
internal collets that allow the mounting of shanks having diameter
between Ø 0.5mm and Ø 10mm (Ref. A) with the length varying
according to the collet used (Ref. B).
In the case of an ER 20 collet mounting, it is possible to use
internal collets that allow the mounting of shanks having diameter
between Ø 1mm and Ø 13mm (Ref. A) with the length varying
according to the collet used (Ref. B).
In the case of an ER 25 collet mounting, it is possible to use
internal collets that allow the mounting of shanks having diameter
between Ø 1mm and Ø 16mm (Ref. A) with the length varying
according to the collet used (Ref. B).
In the case of an ER 32 collet mounting, it is possible to use
internal collets that allow the mounting of shanks having diameter
between Ø 2mm and Ø 20mm (Ref. A) with the length varying
according to the collet used (Ref. B).
26
The diameter of the point of the tool must never exceed the maximum diameter
allowed for the shank, unless other specifications in the technical data sheet.
B
A
MC s.r.l. © - 0103h00gb.fm110208