XV-5080 Gebruikers Handleiding - Roland

■System Parameters
SYSTEM General #1 ([SYSTEM/UTILITY]-[F1(General)])(p. 174)
Group Parameter Value
Setup LCD contrast LCD contrast 1–10
Patch Remain Patch remain switch OFF, ON
Power Up Mode Power up mode LAST-SET, DEFAULT
Character Style Character Style TYPE1–4
Rhythm Edit Key Rhythm edit key PANEL, PANEL&MIDI
SCSI Probe Time SCSI probe time 1–10
Master Level Master level 0–127
Tune Master Tune 415.3–466.2Hz
Key Shift Key Shift -24–+24 semitones
System Tempo Clock Source Clock source INT, MID
Tempo System tempo 20–250
SYSTEM General #2 ([SYSTEM/UTILITY]-[F1(General)])(p. 175)
Group Parameter Value
Scale Tune Switch Scale tune switch OFF, ON
PATCH SCALE C–B Scale tune C–B -64–+63
KEY SCALE C–B Scale tune C–B -64–+63
SYSTEM Output ([SYSTEM/UTILITY]-[F2(Outp&EQ)-[F2(Output)])(p. 175)
Group Parameter Value
Digital Interface Master Clock Master Clock INTERNAL/R-BUS/WORD CLOCK IN
Master Freq Master Frequency 44.1/48.0kHz
DIF Control DIF-AT Clk Select DIF-AT Clock select R-BUS/ADAT/DA-88
Output Mix/Parallel Mode Mix/Parallel MIX, PARALLEL
SYSTEM EQ ([SYSTEM/UTILITY]-[F2(Outp&EQ)-[F2(EQ)])(p. 175)
Group Parameter Value
Output A-D L.F Low Frequency 200/400Hz
L.G Low Gain -15–+15
H.F High Frequency 2000/4000/8000Hz
H.G High Gain -15–+15
SYSTEM MIDI ([SYSTEM/UTILITY]-[F3(MIDI)])(p. 175)
Group Parameter Value
MIDI Receive Ch Perform Ctrl Ch Performance control channel 1–16, OFF
Patch/Rhy Rx Ch Patch/Rhythm set receive channel 1–16
System Exclusive Device ID Device ID number 17–32
Receive Sw Receive exclusive switch OFF, ON
MIDI Tx Transmit Edit Data Transmit edit data switch OFF, ON
Stack Mode Stack mode OFF, 2–8
Number Stack number 1–8
Rx Switch Program Change Program Change OFF, ON
Rx Bank Select Receive bank select switch OFF, ON
Rx GM1 On Receive GM1-ON switch OFF, ON
Rx GM2 On Receive GM2-ON switch OFF, ON
Rx GS Reset Receive GS Reset switch OFF, ON
SYSTEM Control ([SYSTEM/UTILITY]-[F4(Control)])(p. 178)
Parameteroverzicht
Group Parameter Value
System Control 1-4 Source System control assign 1-4 OFF, CC01–95(except 32), PITCH BEND, AFTERTOUCH
241