OS5851L-BR Manual de Instruções Modelo ... - Oregon Scientific

086L004968-026
31/75
REV:1
• Charge battery.
• Make sure base is not plugged into an outlet with another household appliance.
Phone beeps
• Place handset in base for a minimum of 20 seconds to reset the security code. If
that does not work, charge battery for 12 continuous hours.
• Clean charging contacts on handset and base with a soft cloth or an eraser.
• See solutions for No dial tone.
• Replace battery.
Dialing from Memory
• Did you program the directory keys correctly
• Did you follow proper dialing sequence
• Make sure the TONE/PULSE dialing mode is set to TONE or PULSE according to
your phone service.
• Did you reprogram directory after a power outage or battery replacement
No dial tone/phone will not dial out
• Check that the AC power adapter is plugged into a working AC power outlet.
• Check all telephone cord connections or try another wall jack
• Do a basic reset of the phone: Disconnect the phone from the wall and remove the
battery for 30 minutes and then re-install as instructed by the manual.
• Try other phones in the house to ensure it is not a line problem with the telephone
company.
• Was the battery charged for at least 12 - 15 hours
• Is the "LOW BATTERY INDICATOR" on
Can’t hear the ring signal
• Check the ringer volume controls; verify that the switch is not set to "Off".
• Check that the AC power adapter is plugged into a working AC power outlet.
• Check all telephone cord connections or try another wall jack.
EN
Can’t receive or make phone calls
• Check if the phone is set to the correct type of service, either Tone or Pulse
• Check that the AC power adapter is plugged into a working AC power outlet.
• Check all telephone cord connections or try another wall jack
• Check to make sure that the Battery is properly installed and connected
27