rozprawa doktorska - Wydział Fizyki, Astronomii i Informatyki ...

[97] Y. Nakazaki, and S. Yamashita, “Fast and wide tuning range wavelength-sweptfiber laser based on dispersion tuning and its application to dynamic FBGsensing,” Opt. Express, 17(10), 8310-8318 (2009).[98] M. P. Minneman, J. Ensher, M. Crawforda et al., "All-Semiconductor High-Speed Akinetic Swept-Source for OCT," Proceedings of SPIE. 8311, 831116.[99] F. M. De Sopra, H. P. Zappe, M. Moser et al., “Near-infrared vertical-cavitysurface-emitting lasers with 3-MHz linewidth,” Photonics Technology Letters,IEEE, 11(12), 1533-1535 (1999).[100] E. C. Vail, G. S. Li, Y. Wupen et al., “High performance and novel effects ofmicromechanical tunable vertical-cavity lasers,” Selected Topics in QuantumElectronics, IEEE Journal of, 3(2), 691-697 (1997).[101] I. Grulkowski, J. J. Liu, B. Potsaid et al., “Retinal, anterior segment and full eyeimaging using ultrahigh speed swept source OCTwith vertical-cavity surfaceemitting lasers,” Biomed. Opt. Express, 3(11), 2733-2751.[102] K. Karnowski, M. Gora, B. Kaluzny et al., [Swept source OCT imaging ofhuman anterior segment at 200 kHz] Spie-Int Soc Optical Engineering,Bellingham(2009).[103] R. H. Stolen, “Nonlinearity in fiber transmission,” Proceedings of the IEEE,68(10), 1232-1236 (1980).[104] R. G. Smith, “Optical Power Handling Capacity of Low Loss Optical Fibers asDetermined by Stimulated Raman and Brillouin Scattering,” Appl. Opt., 11(11),2489-2494 (1972).[105] D. R. Dykaar, S. G. Grubb, J. Simpson et al., "2.5 Gb/s Raman Amplifier at 1.3µm in Germanosilicate Fibers," 1995 OSA Technical Digest Series. 8, PD1.[106] P. B. Hansen, A. J. Stent, L. Eskilden et al., “High sensitivity 1.3 μmoptically preamplified receiver using Raman amplification,” Electronics Letters,32(23), 2164-2165 (1996).[107] C. Simonneau, C. Moreau, L. Gasca et al., "Highly Erbium-Doped FibersCharacterization and Modeling for Erbium Doped Fiber Amplifiers in WDMRegime," Technical Digest (CD). WB4.[108] B. Pedersen, W. J. Minisalco, S. Zemon et al., "Neodymium- andpraseodymium-doped fiber power amplifiers," 1992 OSA Technical DigestSeries. 17, WB4.[109] V. A. Aseev, A. S. Zlatov, N. V. Nikonorov et al., “Gain spectra in ytterbiumerbiummetaphosphate glasses for microlasers,” J. Opt. Technol., 75(3), 203-205(2008).[110] P. Yan, S. Yin, and M. Gong, “175-W continuous-wave master oscillator poweramplifier structure ytterbium-doped all-fiber laser,” Chin. Opt. Lett., 6(8), 580-582 (2008).[111] V. Morin, E. Taufflieb, and I. Clarke, "+20 dBm Praseodymium Doped FiberAmplifier single-pumped at 1030 nm," OSA Trends in Optics and PhotonicsSeries. 16, FAW11.[112] K.-I. Suzuki, Y. Fukada, K. Saito et al., "Gain-Clamped Praseodymium-DopedFiber Amplifier for Burst-Mode Amplification," Technical Digest (CD). WC2.[113] T. Whitley, R. Wyatt, D. Szebesta et al., “High output power from an efficientpraseodymium-doped fluoride fiber amplifier,” Photonics Technology Letters,IEEE, 5(4), 401-403 (1993).[114] Y. S. Seo, R. Sasahara, Y. Fujimoto et al., "10.6 dB gain at a 1310 nmwavelength for a bismuth-doped silica fiber amplifier." FE2_2.125