GEL 244 - ERTECH Elektronik AG

English
Boring and milling scheme:
4.3 Removal of the probe
STOP
M4
A
B
27 0,1
18 GEL 244
A
B
~
5 +1
r a
22 +1
Axis of rotation
4 H6 2 deep
r a = d a/2 (d a = OD of toothed wheel)
measures in mm
Only remove the MiniCoder with the distance gauge attached!
Without the distance gauge the permanent magnet in the MiniCoder will attract
the measuring system to the tooth profile thus possibly causing the measuring
system being damaged.
Mechanical impacts onto the measuring surface of the MiniCoder will
damage the system!
⇒ Insert the distance gauge between the MiniCoder and the measuring toothed wheel
⇒ Loosen the two M4 screws
⇒ Remove the MiniCoder
Avoid any mechanical contact between the measuring system of the MiniCoder
and the tooth profile!
5. Electrical connection
According to the type of MiniCoder (see Type code on page 15) the following pin layout is
applicable:
Line
Signal/function
color Track K KM, KN T TN
white 1
brown /1
pink 2
black /2
grey N
yellow /N
green Sense
red U B = +5 V ± 5%
blue 0 V (GND)
Screen is not wired
in the probe.