USER MANUAL - Effekta
USER MANUAL - Effekta
USER MANUAL - Effekta
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
2<br />
INSTALLATION - INSTALLATION<br />
UPS 60 -120 kVA<br />
- Entfernen Sie die Schutzfolie womit das<br />
Gerät umwickelt ist.<br />
- Mit einem Gabelstapler vorsichtig die USV<br />
von unten aufnehmen, nur wenig anheben<br />
und vorsichtig auf den Boden abstellen. Die<br />
USV ist mit Räder ausgerüstet die ein<br />
müheloses Versetzen erlauben.<br />
- Wir empfehlen das Verpackungsmaterial<br />
aufzuheben; es wird dann von Nutzen sein<br />
wenn die Anlage wieder verpackt werden<br />
muss (z.B.: bei Rückgabe, bei einschicken<br />
an die Servicestelle, bei einem Umzug).<br />
- Vergewissern Sie sich dass das Gerät nicht<br />
beschädigt ist, ansonsten benachrichtigen<br />
Sie sofort den Wiederverkäufer.<br />
2.1.5. Einlagerung<br />
Wenn die Anlage nicht sofort installiert wird,<br />
muss diese an einen feuchte- und<br />
wärmegeschützten Ort eingelagert werden<br />
(zwischen +0 und +40 °C Raumtemperatur und<br />
weniger als 95% RH, nicht kondensierend).<br />
Wenn eine Batterie im Lieferumfang<br />
enthalten ist, stellen Sie ausserdem sicher,<br />
dass bis zur nächsten Batteriewiederaufladung<br />
nicht mehr als 6 Monate<br />
vergehen. Spätestens dann muss die USV<br />
provisorisch angeschlossen und für die<br />
erforderliche Wiederaufladezeit eingeschaltet<br />
werden.<br />
Siehe hierzu Kap. 2.5 - Provisorischer Anschluss<br />
für die Wiederaufladung der Batterie.<br />
2 - 6 - Installation / Installation<br />
DT0344, Betriebsanleitung , Ausgabe 00 - Technical handbook, Issue 00<br />
- Remove the cellophane wrapping utilized<br />
as protection packing.<br />
- Slide the forks of the lift truck under the UPS<br />
and after having lifted it a few centimeters<br />
from the floor, back up and lay it down. UPS<br />
is provided with wheels to easily move it<br />
around.<br />
- Do not throw away the packing material in<br />
that it might be used again to repack the<br />
equipment if having to send it back or to<br />
send it to maintenance centers or for removal<br />
purposes.<br />
- Check that the equipment has not been<br />
damaged. If otherwise immediately contact<br />
the Sales Representative.<br />
2.1.5. Storing<br />
Should the equipment not be installed immediately<br />
it must be stored in a room so as to<br />
protect it against excessive humidity and against<br />
very high heat sources i.e., +5° to +40°C, and<br />
humidity not lower than 95% and moistureless.<br />
If battery cubicle is supplied, make sure that<br />
not more than 6 months pass from the time<br />
the battery had last been recharged.<br />
After such period temporarily connect the UPS<br />
to mains and activate it for the time required to<br />
recharge the batteries.<br />
Refer to para. 2.5 – Temporary connection to<br />
enable battery recharge.