Einbauanleitung Snow Way

c WARNINGFailure to properly connect plow lights tovehicle light harness will prevent plow lightsfrom functioning. Follow proper procedure toconnect light harnesses and test lights beforeoperating.BELLCRANKFAILURE TO FOLLOW CAN RESULT IN INJURYOR DEATHLIFTLINK9. Plug control harness on plow into truck. Plug plowcontrol inside truck cab.10. Raise, Lower and angle plow to make sure no hosesor wires pinch in the plow mechanism.WIRE LOCK PINA-FRAME BOTTOMCYLINDERRODCYLINDERLOCKCLAMPc WARNINGAlways install the cylinder lock clamp when theplow blade is raised and the operator is notengaged in plowing operations. Equipmentfailure or inadvertent operation of the plowcontrol while driving could allow the plow bladeto fall, resulting in injury.FAILURE TO FOLLOW CAN RESULT IN INJURYOR DEATH1. Raise the plow to the full UP position.2. Turn the ignition OFF and apply the parking brake.3. Turn OFF the hand-held controller.4. Remove the pin from the cylinder lock clamp.5. Position the cylinder lock clamp around the exposed(chrome) portion of the lift cylinder with the open side ofthe cylinder lock up. Install the pin. (See Figure 1-18).Figure 1-186. Lower the plow so that cylinder lock clamp is tightagainst cylinder.c WARNINGFailure to lower plow onto clamp could blockheadlights resulting in an accident.FAILURE TO FOLLOW CAN RESULT IN INJURYOR DEATHChoose a location for the plow storage, which will allowthe plow to be removed from the vehicle and not bemoved after removal. Also, choose a location that will notallow the plow stand to sink into the ground. A dry,protected area is recommended.1. Lower plow to the ground, put vehicle in park, turn offthe engine and set the parking brake.2. Disconnect the plow lights from the truck lightharness (See Figure 1-19). Disconnect the plow controlharness and replace the protective cap.