Einbauanleitung Snow Way

PROBLEM PROBABLE CAUSE CORRECTIVE ACTIONBlade will not angle(motor runs)Hydraulic fluid level lowCrossover pressure relief valve setting too lowLow or no current available at angle coil (A or D)Angle coil (A or D) inoperativeAngle cylinder binding or bentPick-up tube not submerged in fluidAngle valve (A or D) not operatingSee Maintenance sectionRefer to dealerRefer to dealerRefer to dealerRefer to dealerSee Maintenance sectionRefer to dealerUnit angles very slowly Hydraulic fluid level low See Maintenance sectionUnit angles in onedirection onlyUnit does not holdangle.Note: This problem isusually noted whenpushing snow.Fluid leaking at powerunitCrossover relief valve pressure setting too lowImproper oil viscosity for outside air temperature,unit not at normal operating temperatureDamaged cylinderCylinder packing improperly torqued or dryCrossover relief valve sticking or stuckAngle coil (A or D) inoperativeLow or no current available at angle coil (A or D)Angle valve (A or D) stuck/stickingAngle cylinder bindingCrossover relief valve pressure setting too lowCrossover relief valve sticking or stuckPilot check valve has debris or damaged pistonHydraulic fittings not torqued properly (too tight,too loose)0-rings between valve block and base are worn/missing or not seating properly0-rings between base and reservoir worn or notseating properlyReservoir over-fullPump shaft seal leakingValve block Cap Screws looseReservoir fasteners looseRefer to dealerSee Maintenance sectionRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerRefer to dealerSee Maintenance sectionRefer to dealerRefer to dealerRefer to dealer