LC-46/52HD1E Operation-Manual GB - Sharp
LC-46/52HD1E Operation-Manual GB - Sharp
LC-46/52HD1E Operation-Manual GB - Sharp
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
28<br />
Watching DVB broadcasts<br />
Conditional Access Module (CI<br />
Module)<br />
In order to receive coded digital stations, a Conditional<br />
Access Module (CI Module) and a CA Card must be<br />
inserted in the CI slot of your TV set. (Page 6)<br />
The CI Module and the CA Card are not supplied<br />
accessories. They are usually available from your<br />
dealer.<br />
Inserting the CA Card into the CI Module<br />
1 Make sure the TV set is switched off with the<br />
main power switch (a) on the set, or pull the<br />
AC plug.<br />
With the side with the gold coloured contact<br />
chip facing the side of the CI Module marked<br />
with the provider’s logo, push the CA Card<br />
into the CI Module as far as it will go. Note the<br />
direction of the arrow printed on the CA Card.<br />
Inserting the CI Module in the CI slot<br />
Remove the rear terminal cover.<br />
2<br />
3<br />
4<br />
Remove the CI slot cover.<br />
Carefully insert the CI<br />
Module in CI slot 1 or CI slot<br />
2 with the contact side<br />
forward.<br />
The logo on the CI Module<br />
must be facing outward,<br />
from the rear of the TV. Do<br />
not use excessive force.<br />
Make sure the module is not<br />
bent in the process.<br />
If the CI Module is correctly installed, the eject<br />
button protrudes a little further.<br />
Switching on the TV set<br />
After powering on with the new CI Module inserted,<br />
a dialogue will appear. You must conduct a station<br />
search.<br />
5<br />
6<br />
Press OK to start the station wizard.<br />
Check the recommended search routine<br />
parameters and then start the search.<br />
7 Replace the cover.<br />
Checking CI Module information<br />
NOTE<br />
• Make sure that CI Module is properly inserted.<br />
• This menu is only available for digital stations.<br />
1<br />
2<br />
3<br />
4<br />
Press MENU and the TV menu screen displays.<br />
Press c/d to select “Setup”, and then press b<br />
to move down.<br />
Press a/b to select “Miscellaneous”, and then<br />
press b to move down.<br />
Press c/d to select the CI Module you want to<br />
check, and then press OK.<br />
• The content of this menu depends on the provider of<br />
the CI Module.<br />
Removing the CI Module<br />
• Switch off the TV set’s main power switch (a).<br />
1 Remove the cover from the rear of<br />
the set.<br />
2<br />
3<br />
4<br />
Press in the eject button on the<br />
appropriate module slot, and the<br />
module will release.<br />
Remove the module from the set.<br />
Replace the cover.