installation an operation for sea tel model coastal 18 satellite tv ...

Coastal 18 Ku-Band TVRO Setup
5.2.7. SAT5 - Fifth Satellite Parameters
Access all of the SAT5 individual parameters via a sub menu. If a second SAVED satellite if not needed,
preset SAT5 to empty/blank so NEXT will skip over this selection when you are switching satellites.
All of the SAT5 parameters are set exactly the same way that the SAT1 parameters were set, but would
be set to different choices. Refer to the parameter setting information in the SAT1 – First Satellite
Parameters paragraphs to set PRESET, NAME, LON, FREQ, ALT FREQ, BAUD, FEC, NID and POL
TRIM for a fifth satellite you wish to use periodically.
5.2.8. SAT6 - Sixth Satellite Parameters
Access all of the SAT6 individual parameters via a sub menu. If a second SAVED satellite if not needed,
preset SAT6 to empty/blank so NEXT will skip over this selection when you are switching satellites.
All of the SAT6 parameters are set exactly the same way that the SAT1 parameters were set, but would
be set to different choices. Refer to the parameter setting information in the SAT1 – First Satellite
Parameters paragraphs to set PRESET, NAME, LON, FREQ, ALT FREQ, BAUD, FEC, NID and POL
TRIM for a sixth satellite you wish to use periodically.
5.2.9. FACTORY SETTINGS
Accessing the Factory Settings parameters should ONLY be done by a qualified technician from an
authorized Sea Tel dealer. The Model Serial Number can be found on the blue and silver label below the
reflector, on the blue frame of the pedestal. The parameters are:
5.2.9.1. MODEL COASTAL ##
This parameter sets all of the internal drive, scale factor and limits for the motors, gear ratios and
sensors FOR THIS MODEL ANTENNA.
NOTE: The MODEL parameter setting is saved in the PCU, therefore, MUST
be set whenever the PCU is changed.
WARNING: Improper setting of this parameter WILL cause the antenna to
malfunction.
1 Press the NEXT key to SELECT this sub-menu parameter for adjustment.
2 Once selected, press ▲ & ▼ arrow keys to scroll through a list of model number choices.
This list may change in future software revisions. The current choices are:
18 18 inch diameter reflector
24 24 inch diameter reflector
30 30 inch diameter reflector
3 When the correct model value is displayed, press the SAVE key to save the Model Number
parameters. This saves the drive, scale factors and limits for this antenna. If this parameter
is NOT set correctly, the antenna WILL malfunction.
4 If you want to edit any of the Serial Number parameter, press the ▼ arrow key.
5 If you do not want to edit the Serial Number, press SAVE again to exit the sub-menu and
return to the SAT main menu display.
5-7