Mercedes-Benz SLR McLaren. Operator's Manual.

Practical hints
Towing the vehicle
Installing/reinstalling towing eye bolt
Take the towing eye bolt 1 from its
storage compartment ( page 342).
362
i
The gear selector lever will remain
locked in position P and the SmartKey
will not turn in the starter switch if the
battery is disconnected or discharged.
See notes on the battery ( page 356).
!
Only secure the tow bar to the towing
eye bolt. The vehicle could otherwise
be damaged.
!
Your vehicle is equipped with a front
towing eye bolt only ( page 362).
You cannot tow other vehicles with
your vehicle.
1 Towing eye bolt
Remove cover from the access hole.
Screw towing eye bolt 1 in to its stop.
Remove the towing eye bolt when you
no longer need it. To do this, carry out
the above steps in reverse order.
Points to bear in mind
The vehicle must not be tow-started.
If the vehicle is to be towed, only tow it
with all wheels on the ground.
If the vehicle has suffered transmission
damage, only tow it with the propeller
shaft disconnected.
Before towing the vehicle, make sure
the battery is connected and charged.
Otherwise you will not be able to switch
on the ignition and move the selector
lever to N. There will then be no power
assistance when steering and braking.
Transporting the vehicle
The towing eye bolt can be used to pull the
vehicle onto a trailer or transporter for
transporting purposes.
Move the selector lever to N.
!
Due to the low clearance height of the
SLR, care must be taken when loading
and unloading from a transporter to
avoid damaging the vehicle body work.
To secure the vehicle, only tie it down
by the wheels or tires. Otherwise it
could be damaged.