Simulating Tread Systems in Creo Elements/Pro 5.0

More documents

Recommendations

Info

Bring out three axle_d-shaft_2011.prt and constrain each of them to different area of the channel by again using the Pin connection set: 1. Axis Alignment, 2. Translation, 3. Rotation Axis. Constraining first axle Constraining second axle Constraining third axle
Bring out three idler wheels and constrain each of them to different areas of the channel by using the Mate and Insert constraint types. Constraining first idler wheel Constraining second idler wheel Constraining third idler wheel
Page 3 and 4: Upon starting Creo, go to: File Ne
Page 5 and 6: Press the Assembly icon on the righ
Page 7 and 8: Set the 416 mm channel from the Aut
Page 9 and 10: Constrain the DC motor mount to the
Page 11: Bring out tetrix_tt_idler_wheel_201
Page 15 and 16: In Mechanism mode, select Servo Mot
Page 17 and 18: Define the servo motors for each id
Page 19 and 20: To create the belt track, select th
Page 21 and 22: The Component Create window will ap
Page 23 and 24: Change Applications from Mechanism
Page 25 and 26: Under the Point on Line constraint,
Page 27 and 28: Select a second Slot connection opt
Page 29 and 30: Select the green check after comple
Page 31 and 32: Click on the Analysis Definition ic
Page 33 and 34: Select the Playback icon in order t
Page 35 and 36: Select Playback in the Playback win
Page 37: Continue connecting and defining se

Simulating Tread Systems in Creo Elements/Pro 5.0

Create successful ePaper yourself

Delete template?

Save as template?