Simulating Tread Systems in Creo Elements/Pro 5.0

More documents

Recommendations

Info

Select the Belt icon in order to open the window for creating a belt track around the sprocket and idler wheels. Information for setting up belt track Locating Belt icon and opening window Belt Icon
To create the belt track, select the outer rim of the sprocket and then the outer rim of each of the idler wheels while holding down the ctrl key. Starting belt track with sprocket and first idler wheel Adding second idler wheel to belt track Adding third idler wheel to belt track
Page 3 and 4: Upon starting Creo, go to: File Ne
Page 5 and 6: Press the Assembly icon on the righ
Page 7 and 8: Set the 416 mm channel from the Aut
Page 9 and 10: Constrain the DC motor mount to the
Page 11 and 12: Bring out tetrix_tt_idler_wheel_201
Page 13 and 14: Bring out three idler wheels and co
Page 15 and 16: In Mechanism mode, select Servo Mot
Page 17: Define the servo motors for each id
Page 21 and 22: The Component Create window will ap
Page 23 and 24: Change Applications from Mechanism
Page 25 and 26: Under the Point on Line constraint,
Page 27 and 28: Select a second Slot connection opt
Page 29 and 30: Select the green check after comple
Page 31 and 32: Click on the Analysis Definition ic
Page 33 and 34: Select the Playback icon in order t
Page 35 and 36: Select Playback in the Playback win
Page 37: Continue connecting and defining se

Simulating Tread Systems in Creo Elements/Pro 5.0

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?