Simulating Tread Systems in Creo Elements/Pro 5.0

More documents

Recommendations

Info

In the Playback window, select Capture to open the Capture window. In the Capture window, save the adjusted playback as a .mpg (video) and select OK.
Continue connecting and defining servo motors for the tread links. This may take a while; however, be patient!!! … all of the hard work will pay off in the end. (Then, work on the Playback when totally done.) Tread System for the Bounty Hunters FTC Team
Page 3 and 4: Upon starting Creo, go to: File Ne
Page 5 and 6: Press the Assembly icon on the righ
Page 7 and 8: Set the 416 mm channel from the Aut
Page 9 and 10: Constrain the DC motor mount to the
Page 11 and 12: Bring out tetrix_tt_idler_wheel_201
Page 13 and 14: Bring out three idler wheels and co
Page 15 and 16: In Mechanism mode, select Servo Mot
Page 17 and 18: Define the servo motors for each id
Page 19 and 20: To create the belt track, select th
Page 21 and 22: The Component Create window will ap
Page 23 and 24: Change Applications from Mechanism
Page 25 and 26: Under the Point on Line constraint,
Page 27 and 28: Select a second Slot connection opt
Page 29 and 30: Select the green check after comple
Page 31 and 32: Click on the Analysis Definition ic
Page 33 and 34: Select the Playback icon in order t
Page 35: Select Playback in the Playback win

Simulating Tread Systems in Creo Elements/Pro 5.0

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?