Simulating Tread Systems in Creo Elements/Pro 5.0

More documents

Recommendations

Info

In Assembly, turn off datum planes, coordinate systems, and 3D annotation display by clicking on each of their icons in the upper right hand corner. Datum Plane Icon “ON” Initial Assembly window Modified Assembly window 3D Annotation Display Icon “ON” Coordinate Systems Icon “ON” Datum Plane Icon “OFF” 3D Annotation Display Icon “OFF” Coordinate Systems Icon “OFF”
Press the Assembly icon on the right-hand side. Then, right click on 2011_FTC_KOP Set Working Directory. Working Directory where 2011_FTC_KOP components will now be found 2011_FTC_KOP Set Working Directory Assembly Icon
Page 3: Upon starting Creo, go to: File Ne
Page 7 and 8: Set the 416 mm channel from the Aut
Page 9 and 10: Constrain the DC motor mount to the
Page 11 and 12: Bring out tetrix_tt_idler_wheel_201
Page 13 and 14: Bring out three idler wheels and co
Page 15 and 16: In Mechanism mode, select Servo Mot
Page 17 and 18: Define the servo motors for each id
Page 19 and 20: To create the belt track, select th
Page 21 and 22: The Component Create window will ap
Page 23 and 24: Change Applications from Mechanism
Page 25 and 26: Under the Point on Line constraint,
Page 27 and 28: Select a second Slot connection opt
Page 29 and 30: Select the green check after comple
Page 31 and 32: Click on the Analysis Definition ic
Page 33 and 34: Select the Playback icon in order t
Page 35 and 36: Select Playback in the Playback win
Page 37: Continue connecting and defining se

Simulating Tread Systems in Creo Elements/Pro 5.0

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?