Simulating Tread Systems in Creo Elements/Pro 5.0

More documents

Recommendations

Info

Under the Point on Line constraint, click on “Select component item(s)” box. Then, select the mid-bottom vertex of the tread link as shown below. “Select component item(s)” box Selecting Point on Line component item of the first Slot set Mid-bottom vertex
Select a second Slot connection option. Again, click on the “Select assembly item(s)” box under the Point on Line constraint and select the seven parts of the belt while holding down the ctrl key. Second Slot connection Selecting Point on Line assembly items of the second Slot set
Page 3 and 4: Upon starting Creo, go to: File Ne
Page 5 and 6: Press the Assembly icon on the righ
Page 7 and 8: Set the 416 mm channel from the Aut
Page 9 and 10: Constrain the DC motor mount to the
Page 11 and 12: Bring out tetrix_tt_idler_wheel_201
Page 13 and 14: Bring out three idler wheels and co
Page 15 and 16: In Mechanism mode, select Servo Mot
Page 17 and 18: Define the servo motors for each id
Page 19 and 20: To create the belt track, select th
Page 21 and 22: The Component Create window will ap
Page 23 and 24: Change Applications from Mechanism
Page 25: Under the Point on Line constraint,
Page 29 and 30: Select the green check after comple
Page 31 and 32: Click on the Analysis Definition ic
Page 33 and 34: Select the Playback icon in order t
Page 35 and 36: Select Playback in the Playback win
Page 37: Continue connecting and defining se

Simulating Tread Systems in Creo Elements/Pro 5.0

Create successful ePaper yourself

Delete template?

Save as template?