Sibille Fameca Electric

Sibille_EN_01_TOOL_ELEC_3_063-fin.qxd:Mise en page 1 13/01/10 15:19 Page 80
B y p a s s a n d a c c e s s o r i e s
80
Beroshunt system
- Beroshunt system, M8 connector -
TB16 - Unipolar junction box with forks and key
Use : this junction box has 6 intermediate end fittings into which the ends of
the shunts TS 41 are crewed in pairs. The “T” key TC 75 is for tightening the
end rods onto the junction box.
Réf. | Weight (g)
TB16 (3241) | 600
TP82FF - 30 A fuseholder for bypass (female-female
end)
Réf. | Weight (g)
TP82FF (3207) | 110
TP82FB - 30 A fuseholder for mini clamp + banana
plug
Réf. | Weight (g)
TP82FB (3205) | 110
TP82MF - 30 A fuseholder for bypass male-female
end
Réf. | Weight (g)
TP82MF (3204) | 110
TS40 - Bypass with 30 A 1 m fuse
Use : the bypass with 30 A fuse is used to ensure that the fault which caused
the fuse to blow has been eliminated before a bare fuse of not more than 60
A is changed. It may also be used during the time required to repair a mains,
such as for a fuse, shunt grid, etc. In this case check that the neon tube is not
alight (box fuse blown).
Bypass with HPC 30 A fuse.
Total length of junction cable 1 m of 35 mm section.
The threaded ends accept clamp TP 65 or TP 66, exceptionally TP 67, TM 07 or
TM 07B.
TOOLS FOR ELECTRICIANS
Réf. | Weight (g)
TS40 (3209) | 490