Sibille Fameca Electric

Sibille_EN_01_TOOL_ELEC_3_063-fin.qxd:Mise en page 1 13/01/10 15:19 Page 86
B y p a s s a n d a c c e s s o r i e s
86
400 and 800A clamps for LV switch boxes
- 400 and 800A clamps for LV switch boxes -
SFE 3436 - 400 A CLAMP for switch box PTV 1400
In compliance with the technical data BT 922.
The clamp maintains the electrical link between a switch board and the
network cable provisory equipped with screw connectors. It is possible to join
generator, mobile transformer, or all other electrical work.
The installation of the clamp carries out by the tightening on the edge of
power
bars of the switch box (bars from 40 x 5 to 120 x 12).
The tightening principle and the slim width allow its installation as well
between the departures equipping the switch box as the top of the bars.
The clamp is fully insulated and maintains the IP2X protection degree. It is
equipped of one or two 400 A sockets allowing the 400 A way with a cable or
800 A with two cables in parallel.
The clamp has an integrate torque limiter allowing a optimal tightening to the
operator.
SFE 3435 - 800 a clamp for switch box PTV 2400
In compliance with the technical data BT 922.
The clamp maintains the electrical link between a switch board and the
network cable provisory equipped with screw connectors. It is possible to join
generator, mobile transformer, or all other electrical work.
The installation of the clamp carries out by the tightening on the edge of
power
bars of the switch box (bars from 40 x 5 to 120 x 12).
The tightening principle and the slim width allow its installation as well
between the departures equipping the switch box as the top of the bars.
The clamp is fully insulated and maintains the IP2X protection degree. It is
equipped of one or two 400 A sockets allowing the 400 A way with a cable or
800 A with two cables in parallel.
The clamp has an integrate torque limiter allowing a optimal tightening to the
operator.
TOOLS FOR ELECTRICIANS