Horizon Memory Craft 12000 - Janome

n
m
41
b The buttonhole is sewn automatically in the
sequence shown. When the buttonhole is finished,
the machine will stop automatically with the needle in
the up position.
Press the thread cutter button and remove the fabric.
n Place a pin just below the bartack at each end to
prevent accidentally cutting the threads. Cut the
opening with the seam ripper. Use an eyelet puncher
to open a keyhole buttonhole.
m After you finish buttonhole sewing, push the
buttonhole lever up as far as it will go.
Patterns B3 to B13 are sensor buttonholes and the
sewing procedure is the same as for buttonhole B1.
However, the sewing sequence varies depending on the
type of the buttonhole.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of buttonhole
stitches over the previous stitches.
After the buttonhole is finished, simply start the machine
again.
Do not raise the foot or buttonhole lever.