Overlock Pintucked Apron - Husqvarna Viking

3. Place the 26” side of the 20” long x 26” wide piece right sides together with the other side of the
“waistband” piece. Serge the seam.
4. Press both seams towards the “waistband”.
5. Fold in half, to measure 26” x 28 1/2”. Place the armhole template in place aligning the straight
edges of the template with the top and sides of the apron. Cut the armholes.
6. Place the apron on the lining fabric and using the apron as your pattern, cut out the lining the
same size as your apron.
7. Pin the ruffle to the bottom of the apron. Keep the pins out of the seam allowance, away from
where the cutter will cut. Adjust the gathers as needed to fit the bottom of the apron. Start the
ruffle edge 1/2” from each edge so it won’t get caught in the lining seam.
8. Pin the corners of the ruffle, in, out of the way of the side seam.
Make the Ties and Strap:
1. Using the marks on your rotary cutter ruler, cut a 60°
angle on one end of one of the 30” x 2 1/2” neck pieces
as shown.
2. Fold over the strip, and using the first end as your guide,
cut the same angle on the other end.
3. Place the trimmed neck strip right side together with the
un-trimmed neck strip.
4. Stitch the two long edges and one short edge.
5. Turn using your Fasturn Tube Turner.
6. Place one of each fabric back tie pieces right sides together. Serge the short and two long edges.
7. Repeat for the other tie.
8. Turn using your Fasturn Tube Turner.
9. Pin the ties in place on the apron as shown, keeping the pins out of the seam
allowance area, well away from where the cutter will cut.
10. Serge all around the apron leaving a 5” opening on one side edge to turn. Turn
through the opening.
11. Place Steam-A-Seam 2 in the opening and press with steam to fuse closed.