INSTRUCTION AND MAINTENANCE MANUAL FOR ... - Jabiru Aircraft

Jabiru Aircraft Pty Ltd
Instruction & Maintenance Manual
6.14 Engine Inspection Chart
Jabiru 3300 Aircraft Engine
Hydraulic Valve Lifter Models
Note: READ ALL INSPECTION RQUIREMENTS PARAGRAPHS PRIOR TO USING THESE
CHARTS.
PROPELLER
Annual Inspection
Each 200 Hours
Each 100 Hours
Each 50 Hours
11 Spinner * * *
12 Spinner Flange * * *
13 Spinner screws * * *
14 Propeller * * *
15 Propeller bolts/nuts - Tension * * *
16 Spinner / Prop Tracking * * *
ENGINE & ENGINE COMPARTMENT
Check for oil, fuel exhaust & induction leaks, then clean
entire engine & compartment before inspection.
1 Check flywheel screw tensions to 24lb.ft 1 *
2
Carburetor air filter –
Check & replace if required
1
Note: if any screws rotate they must be removed, crankshaft and screw threads cleaned then re-installed with fresh Loctite 620 (Use
no more than the size of a match head). Do not remove all flywheel screws at once or loss of valve timing may occur
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
REVISION 0 1 2 3 4 5 6 7 8 9 Dated : Apr 2011 Issued By: DPS Page: 31 of 53
L:\files\Manuals_For_Products\Engine_Manuals\3300_engine_manuals\Hydraulic_Lifters\Working_Copies\JEM3304-9_I&M.doc
* * * *
3 Engine baffles and air ducts *
4 Cylinders *
5 Crankcase & front crankcase seal *
6 Fuel hoses, lines and fittings * * *
7 Intake and exhaust systems * * *
8 Ignition harness, distributor caps & rotors * * *
9 Spark plugs * * * *