INSTRUCTION AND MAINTENANCE MANUAL FOR ... - Jabiru Aircraft

Jabiru Aircraft Pty Ltd
Instruction & Maintenance Manual
7.3 Engine Installation
Jabiru 3300 Aircraft Engine
Hydraulic Valve Lifter Models
No. Operation Tools Required
1 Fit engine to engine mount -
2 Torque engine mount bolts 7/16 Tube Socket
7/16 Ring Open End Spanner
3 Fit muffler (if not already fitted) and fit carburettor
heat muff and hose
3/16 Ball End Allen Key
4 Connect left and right ignition coils leads -
5 Connect Tacho sender -
6 Connect exhaust gas temp (if fitted) -
7 Connect cylinder head sender 18mm Spark Plug socket
8 Connect hourmeter Screw Driver
9 Connect oil temp gauge sender
10 Connect oil pressure gauge sender
11 Connect starter 7/16 Ring Open End Spanner
12 Connect Battery (Earth lead first) 10mm Ring Open End Spanner
13 Connect fuel line Screw Driver
14 Connect Oil Breather Screw Driver
15 Connect Choke Cable Long Nose Pliers
16 Connect Throttle Cable Long Nose Pliers
17 Connect Air Inlet Screw Driver
18 Fit Propeller and spinner 7/16 Ring Open End Spanner
7/16 Torque Wrench
Phillips Screw Driver
19 Fit Cooling Ducts 3/16 Allen Key
20 Prime Fuel system with electric pump and inspect
for leaks
21 Check for oil. Fill if needed. 3.4L oil (3.7 US quarts)
22 Wind over to get oil pressure -
23 Start and inspect for leaks -
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
REVISION 0 1 2 3 4 5 6 7 8 9 Dated : Apr 2011 Issued By: DPS Page: 35 of 53
L:\files\Manuals_For_Products\Engine_Manuals\3300_engine_manuals\Hydraulic_Lifters\Working_Copies\JEM3304-9_I&M.doc
-