OPERATION / SERVICE MANUAL - Midmark

More documents

Recommendations

Info

32 IQmark Digital Spirometer Operation Manual Please refer to the Federal Register or your OSHA representative for additional details about occupational testing. F. Spirometer Handle There are different versions of the Spirometer handle available. Midmark Diagnostics Group offers USB and COM port versions of the handle. The USB handle is designed to operate with a computer. There are two versions of the COM port handle (COM port handles have a DB9 female connector). One version is designed to operate with a Pocket PC device (like a Compaq/HP iPAQ) and the other version is designed to operate with a computer. The model/serial number is listed on the label on the top of the Spirometer handle (under the DPM). This should be used to identify the version of the handle. The model/serial number defines the handle as follows: 03xxx COM port handle for use with a desktop or laptop computer 50xxxx COM port handle for use with a desktop or laptop computer 51xxxx COM port handle for use with a Pocket PC, hand-held device 52xxxx USB port handle for use with a desktop or laptop computer NOTE: 51xxxx handles are switched on when the DPM is in place. To conserve the life of your batteries, be sure to remove the DPM after calibration or testing. In addition, place the DPM in the handle BEFORE entering the test or calibration screen. This will turn the handle on and allow the software to detect the handle. Please contact Midmark Diagnostics Group Customer Service at 800-624-8950, if you have any questions about which handle you have.
III. Operation IQmark Digital Spirometer Operation Manual NOTICE This Spirometer has been designed and tested to meet the appropriate sections of IEC 60601-1-1, IEC 601-1, IEC 60601-1-2, UL 2601-1 and ETL (CSA and UL). A. Introductory Notes This manual describes how to use the various features and the operational sequence most users will follow when operating the IQmark Digital Spirometer. However, you are not restricted to follow this particular sequence. The bottom or right side of each screen has a menu bar that lists other screens that may be accessed. To visit any of these screens, simply click the appropriate button. Of course, certain sequences must always be followed, such as entering a patient’s demographics and medical data prior to performing a Spirometry test. For your convenience, a condensed guide to the operation of the Spirometer with new patients is listed in the Appendix under Spirometry Testing at a Glance. Use this guide until you become more familiar with the use and operation of the program. Appendix N, O, and P can be used for more advanced users and for Pre/Post testing. Pulmonary Function Test or PFT is another term widely used for Spirometry. You may hear people refer to this device as a PFT machine. Technically, a Spirometer is a device used by a patient to perform a PFT. In this manual, the words Spirometer or Spirometry are used when referring to the Midmark Diagnostics Group device and its operation. Prescription Device “Caution: Federal law restricts this device to sale by or on the order of a medical practitioner licensed by the law of the state in which that person practices.” B. Patient Preparation NOTE: The ATS recommends daily calibration of Spirometers using a 3-liter syringe. See Calibration in the Installation section for instructions. Each patient must be prepared for the Spirometer test procedure. It is essential that you comply with the following instructions on patient preparation as closely as possible. Otherwise, the integrity of the Spirometry data may be compromised. Show every patient the proper way to perform a test. It is recommended that the user perform at least one forced expiratory maneuver to demonstrate the procedure to the patient. This test does not have to be performed on this Spirometer but it should be 33
Page 1: OPERATION / SERVICE MANUAL Part Num
Page 4 and 5: ii IQmark Digital Spirometer Operat
Page 6 and 7: IQmark is a registered trademark o
Page 8 and 9: Device Labeling Information vi IQma
Page 11 and 12: I. General Information A. Descripti
Page 13 and 14: Terminal Server Windows Client PC I
Page 15 and 16: IQmark Digital Spirometer Operation
Page 17 and 18: II. System Installation IQmark Digi
Page 23 and 24: Thin Client Channel Setting IQmark
Page 25 and 26: Reports Tab IQmark Digital Spiromet
Page 35 and 36: Trending Tab IQmark Digital Spirome
Page 37 and 38: E. Calibration IQmark Digital Spiro
Page 41: IQmark Digital Spirometer Operation
Page 49 and 50: Field Diagnostic Role IQmark Digita
Page 69 and 70: Side by Side F/V Loops IQmark Digit
Page 71 and 72: IV. Appendix A. Screen Summary Summ
Page 73 and 74: B. Troubleshooting IQmark Digital S
Page 75 and 76: C. Maintenance and Storage Cleaning
Page 77 and 78: E. Interpretation - ATS IQmark Digi
Page 81 and 82: Crapo - Adult, continued IQmark Dig
Page 83 and 84: Knudson - Adult, continued FEF25% (
Page 85 and 86: NHANES III (Hankinson, NLHEP) - Adu
Page 87 and 88: Morris - Adult IQmark Digital Spiro
Page 89 and 90: H. Reference Values - Pediatric IQm
Page 91 and 92: FEF 75% (MEF25%) IQmark Digital Spi
Page 93 and 94:
Hsu - Pediatric IQmark Digital Spir
Page 95 and 96:
IQmark Digital Spirometer Operation
Page 97 and 98:
Page 99 and 100:
J. Spirometry Measurement Parameter
Page 101 and 102:
K. References IQmark Digital Spirom
Page 103 and 104:
L. Technical Service Manual Service
Page 105 and 106:
Page 107 and 108:
Can Not Zero Spirometer handle LED
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
R. Customer Service and Contact Inf
Page 117 and 118:
Brentwood Medical Technology Corp.
Page 119:
Brentwood Medical Technology Corp.
show all

OPERATION / SERVICE MANUAL - Midmark

Create successful ePaper yourself

Delete template?

Save as template?