TigerSwitch 10/100 - SMC

USING THE SYSTEM CONFIGURATION PROGRAM
Parameter Default Description
Flow Control Disabled Used to enable or disable flow control. Flow
control can eliminate frame loss by “blocking”
traffic from end stations or segments connected
directly to the switch when its buffers fill. IEEE
802.3x flow control is used for full duplex. Note
that flow control should not be used if a port is
connected to a hub.
Speed and
Duplex
Auto Indicates current port speed and duplex mode.
Note that Auto-negotiation is not available for
the 100BASE-FX ports. 100BASE-FX is fixed at
100 Mbps, full-duplex. And while 1000BASE-SX
does auto-negotiate duplex mode and flow
control, its speed is fixed at 1000 Mbps.
Viewing the Current Port Configuration
The Port Information screen displays the port type, status, link
state, and flow control in use, as well as the communication speed
and duplex mode. To change any of the port settings, use the Port
Configuration menu.
Port Information : Unit 1 Port 1 - 12
================
Port Type Operational Link FlowControl Speed and
InUse Duplex InUse
-------------------------------------------------------------
1. 10/100TX YES UP NONE 100-FULL
2. 10/100TX YES UP NONE 100-FULL
3. 10/100TX YES UP NONE 100-FULL
4. 10/100TX YES UP NONE 100-FULL
5. 10/100TX YES UP NONE 100-FULL
6. 10/100TX YES UP NONE 100-FULL
7. 10/100TX YES UP NONE 100-FULL
8. 10/100TX YES UP NONE 100-FULL
9. 10/100TX YES UP NONE 100-FULL
10. 10/100TX YES UP NONE 100-FULL
11. 10/100TX YES UP NONE 100-FULL
12. 10/100TX YES UP NONE 100-FULL
Use or arrow keys to move. to select.
2-29