Operating Manual - Winkhaus

Operating Manual EAV 15
6 Power supply
N L
+ V - V
Netzteil/Powersupply
INPUT: 100 - 240V AC; 50/60Hz
OUTPUT: 12V DC; 2A
+ NOTICE!
+ + - -
Aug. Winkhaus GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen · www.winkhaus.de
Subject to technical changes
Print-no. 250 020 1
08/2009
Power supply unit for EAV: 100 - 240V, 50/60Hz, 12V DC, 2A, to
be installed on a top hat mounting rail
STV-Power supply 12V DC/2A 246 977 7
Operation of a second EAV with the same power supply is not possible.
Suitable for additional appliance (e. g. finger scanner ekey home integra),
but follow their power requirements (see the next notice).
CAUTION! It is not allowed to load the power supply with more than 2A
when using EAV + access control system!
+ NOTICE!
Unless you are using a Winkhaus power supply unit, please keep in mind the
following information:
• exclusively for EAV: 12V DC (direct current), stabilized, min. 1,5A
• raise the power by the need of the additional component (1,5A + power
of the additional component) when using EAV + access control system
(e. g. finger scanner)
7 Access control systems
From the outside the door is opened via the access control system (transponder, wireless
remote control).
+ NOTICE!
VdS acceptance: Only with VdS-tested access control systems!
General
information
1
Important
information
Installation
2
Product
description
3
4
Operation
Programming
5
Maintenance
and care
6
Errors
Troubleshooting
7
Technical
specifications
8
Accessories