Operating Manual - Winkhaus
Operating Manual - Winkhaus
Operating Manual - Winkhaus
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Operating</strong> <strong>Manual</strong> EAV 37<br />
Replacing the batteries in the wireless remote control<br />
Aug. <strong>Winkhaus</strong> GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen · www.winkhaus.de<br />
Subject to technical changes<br />
Print-no. 250 020 1<br />
08/2009<br />
• At the button ring hole, pull the colored battery cover from the bottom of the remote<br />
control outwards.<br />
• The battery compartment swings out.<br />
• Replace the batteries.<br />
• Insert two Lithium CR 2016.31 batteries.<br />
+ NOTICE! Pay attention to the correct polarity!<br />
ECO-WATCH! Properly dispose of the batteries as demanded by environmental<br />
regulation!<br />
Teaching wireless remote controls directly via the receiver<br />
8<br />
9<br />
10<br />
11<br />
12<br />
13<br />
8 „P1 button“<br />
9 „green LED“<br />
10 „red LED“<br />
11 „buzzer“<br />
12 „relay“<br />
13 „jumper“ 12V/24V<br />
• If the programming is performed via the receiver, this will have to be freely accessible.<br />
• Press the P1 button of the receiver until the green LED lights up.<br />
• Release the button.<br />
• Activate the desired button of the remote control while the LED is lit up<br />
• As long as the LED is lit, you can program additional remote control buttons.<br />
General<br />
information<br />
1<br />
Important<br />
information<br />
Installation<br />
2<br />
Product<br />
description<br />
3<br />
4<br />
Operation<br />
Programming<br />
5<br />
Maintenance<br />
and care<br />
6<br />
Errors<br />
Troubleshooting<br />
7<br />
Technical<br />
specifications<br />
8<br />
Accessories
Change language