ACO6800+ Installation and Operation Manual - Biznine.com

Failure of Auto/Manual switchover
Sample Scenario One
Chapter 3: Configuration and Operation
If your auto/manual switchover does not work as expected, confirm that the
following parameters have been configured correctly:
• Group (A/B) GPI Input_(1-3) should confirm the GPI Input condition.
• Group A or Group B Manual Switch should confirm the expected setting.
• Group A or Group B Switch (High/Medium/Low) Priority should display
the sort of logic seen in Table 3-6 and Table 3-8.
• Group A or Group B Alarm Switch Level should confirm the triggered
level.
Confirm that the configurable portions of sub-device alarms match your
expectations. (This includes Enable/Disable, Alarm Priority, Trigger Time, and
Clear Time.)
For ACO6800+ISCST modules, ensure that the Video Standard and Operation
Standard parameters have the same setting. The Still Image Mode parameter
must be set to Auto, and the Force Freeze and Force Black parameters must be
set to Off.
The initial settings for sample scenario one are outlined in Table 3-5.
Table 3-5. Sample Scenario One: Parameter Settings
Parameter Setting
Group A Switch High Priority GPI Input
Group A Switch Medium Priority Manual
Group A Switch Low Priority Alarms
Group A Alarm Switch Level 6
Group A Manual Switch Disable
A1 SDI Loss of Video: Priority 6
A1 SDI Loss of Video: Trigger 2 s
A1 SDI Loss of Video: Clear 10 s
ACO6800+ Installation and Operation Manual 27
Copyright © 2009, Harris Corporation