CDM based CFL scheme - Ministry of Power

E.6. Estimation of Emission reductions of a CPA:
E.6.1. Explanation of methodological choices,
provided in the approved baseline and monitoring
methodology applied, selected for a typical SSC-
CPA:
>> The applied AMS IIC version 10, provides
methodological choices to be made. The SSC-CPA shall
indicate the choices in the following manner:
For each replaced appliance/equipment the capacity
or output or level of service (e.g., light output, room
temperature and comfort, the rated output capacity
of air-conditioners etc.) is not significantly larger or
smaller (maximum ± 10%) than the baseline.
The distributed CFL lamps under the CPA shall meet
the applicable Indian Standard IS: 15111 for CFLs
including amendments on date.
The output capacity (rated luminous flux in lumens)
of the distributed CFL shall be within ± 10% of the
baseline ICL lamp replaced as follows:
Baseline ICL Rated Lumen Matching CFL
replaced (Watt) output under SSC-CPA
(Watt)
40 W 440 9-10 W
60 W 720 13-15 W
75 W 900 16-17W
100 W 1200 20-23W
If the devices installed have a constant current
(ampere) characteristics, monitoring shall consist of
monitoring either the "power" and "operating hours"
or the "energy use" of the devices installed using an
appropriate method. Appropriate methods include:
(a) Recording the "power" of the device installed
(e.g., lamp or refrigerator) using nameplate data
or bench tests of a sample of the units installed
and metering a sample of the units installed for
their operating hours using run time meters;
OR
(b) Metering the "energy use" of an appropriate
sample of the devices installed.
32 Bureau of Energy Efficiency
CFLs have constant current (ampere) characteristics,
and hence as per AMS IIC, SSC-CPA shall indicate
monitoring choice as either:
Monitoring SSC-CPA Option
(check on box)
1. "power": p i is the rated
Wattage of the installed
CFL using nameplate
data or bench tests of
a sample of the CFLs
installed.
2. "operating hours" : o i is
the CFL use by metering
a sample of the CFLs
installed using run-time
meters
OR
3. "energy use": Metering
the "energy use" of an
appropriate sample of
the CFLs installed.
E.6.2. Equations, including fixed parametric values,
to be used for calculation of emission reductions of
a SSC-CPA:
>> The emission reduction achieved by the SSC-CPA
project activity shall be determined as the difference
between the baseline emissions and the project
emissions and leakage.
ER = ((BE – PE ) * BP) – LE y y y y
Where:
ER y : Emission reductions in year y (tCO 2 e)
BE y : Baseline emissions in year y (tCO 2 e)
PE y : Project emissions in year y (tCO 2 e)
LE y : Leakage emissions in year y (tCO 2 e)
BP: Baseline penetration factor
Baseline emissions
In the context of the SSC-CPA, the baseline lamp (ICL)
electricity consumption can be derived by its rated
power.
BE = E * EF (2)
y BL,y CO2,ELEC,y
(1)