EPSILON-CF IOM.pdf - Industrial Air

2.3 LIFTING AND SITE HANDLING
Avoid sudden movements and jolts when unloading and positioning the unit. Internal handling procedures must
be conducted with care. Do not exert leverage on the components of the machine. The unit must be lifted by
inserting steel tubes through the lifting attachments shown by the relative labels (yellow arrow).
The unit must be lifted by harnessing it as shown in figure 1: use ropes or straps of sufficient length and spacer
bars to avoid damage to the unit’s side panels and cover.
Alternatively, the unit can be lifted by a forklift truck, inserting the forks under the pallet (see figure 1).
Figure 1
All lifting devices, ropes and sling etc, must be selected by someone
with the required knowledge and be fully responsible for the use
thereof.
The unit must be properly balanced and when using a forklift the
forks should be in a low position.
If the unit is not balanced apply ballast. Any protruding parts should
not be supported by hand.
Do not walk or stand beneath or in the proximity of the load.
Transportation must be by specialised personnel (truck operators,
hook-up personal), equipped with the necessary protection equipment
(overalls, safety shoes, protective gloves, helmets, goggles).
The manufacturer will not accept any responsibility in case of possible
accidents due to the non-observance of these warnings.
Air Blue • 3