Aprilia Scarabeo 4T servicemanual - Scootergrisen

REMOVING THE FRONT COVER
Carefully read p. 2 (GENERAL SAFETY RULES).
♦ Place the vehicle on the center stand.
♦ Unscrew and remove the one screw (1).
CAUTION
Proceed with care.
Do not damage the tabs and/or the slots in which
they fit.
Handle the plastic and painted components with care
and avoid scraping or damaging them.
♦ Remove the front cover (2), by pulling it downwards.
REMOVING THE FRONT INNER SHIELD
Carefully read p. 2 (GENERAL SAFETY RULES).
NOTE Remove the key from the ignition switch.
♦ Remove the footboard, see p. 24 (REMOVING THE
FOOTBOARD).
♦ Remove the lower shield, see p. 24 (REMOVING THE
LOWER SHIELD).
♦ Remove the rubber gasket (3) from the ignition switch.
♦ Unscrew and remove the two screws (4).
♦ Open the cover (5) of the glove compartment.
♦ Unscrew and remove the screw (6).
♦ Remove the front cover, see above (REMOVING THE
FRONT COVER).
♦ Unscrew and remove the two screws (7).
♦ Press the sides of the front outer shield in correspondence
with the arrows (A), (B), (C), and pull it, releasing
the tabs from their slots.
CAUTION
Proceed with care.
Do not damage the tabs and/or the slots in which
they fit.
Handle the plastic and painted components with care
and avoid scraping or damaging them.
♦ Remove the front inner shield (8).
NOTE Upon reassembly, make sure that the tabs are
correctly inserted.
6
Release 00 2003-02
5
1
Scarabeo 50 I.E.-50/100 4T
7
2
3
4
8
25