Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
REAR WHEEL<br />
DISASSEMBLY<br />
Carefully read p. 2 (GENERAL SAFETY RULES).<br />
A dirty disc soils the pads, with consequent reduction<br />
of the braking efficiency. Dirty pads must be replaced,<br />
while dirty discs must be cleaned with a high-quality<br />
degreaser.<br />
Riding with damaged rims is dangerous for the rider,<br />
the vehicle and other people.<br />
Check the conditions of the wheel rim and the tire; if<br />
in any way damaged, replace them. While reassembling<br />
the wheel, be careful not to damage the brake<br />
line, the disc and the pads.<br />
♦ Remove the exhaust silencer, see p. 69 (EXHAUST SI-<br />
LENCER).<br />
♦ Deflate the rear tire completely.<br />
NOTE To unscrew the wheel nut (1), it is necessary to<br />
lock the rotation of the wheel.<br />
♦ Pull the rear brake lever (2) completely, then put a small<br />
piece of cardboard (3) on the grip and keep the rear<br />
brake lever pulled by holding it against the grip by<br />
means of a tie wrap (4).<br />
♦ Remove the cover (5).<br />
♦ Unscrew and remove the nut (1)and the washer.<br />
NOTE Upon reassembly, use a new wheel nut. Do not<br />
reassemble your vehicle using the old wheel nut. This<br />
wheel nut is of a special type.<br />
Nut (1) tightening torque: 110Nm (79.56 ftlb).<br />
♦ Remove the tie wrap (4) and the cardboard (3).<br />
♦ Release the rear brake lever (2).<br />
♦ Extract the wheel 100 .<br />
♦ Remove the rear brake caliper, see p. 52 (REMOVING<br />
THE REAR BRAKE CALIPER).<br />
♦ Extract the wheel.<br />
Reassembly:<br />
♦ Make sure that the following components are not dirty:<br />
– tire;<br />
– wheel;<br />
– rear brake disc ;<br />
– rear brake caliper .<br />
WARNING<br />
After servicing the brakes, always check them for<br />
function. If the stroke of the lever is excessive, or if<br />
you detect that the effectiveness of the brakes is<br />
reduced in any way, check the brake system, see p. 47<br />
(DISC BRAKES) it may be necessary to bleed the<br />
system, or there may be some other problem with the<br />
brake system. Never ride your vehicle in traffic immediately<br />
after servicing the brakes.<br />
Always apply the brake pedal or lever several times<br />
before riding your vehicle. Then, try your vehicle in a<br />
parking lot or other safe area with little traffic to<br />
ensure that the brakes are working properly. Failure<br />
to observe this warning can lead to a serious accident<br />
with subsequent serious injury or death.<br />
Check the tightening torques, centering and balancing<br />
of the wheel, see p. 55 (INSPECTING THE<br />
WHEELS). These are critical safety operations, and<br />
failure to observe this warning could lead to an upset<br />
with subsequent serious injury or death.<br />
60<br />
WARNING<br />
Release 00 2003-02<br />
100 100<br />
<strong>Scarabeo</strong> 50 I.E.-50/100 <strong>4T</strong>