Aprilia Scarabeo 4T servicemanual - Scootergrisen

REMOVING THE SADDLE SUPPORT
Carefully read p. 2 (GENERAL SAFETY RULES).
♦ Remove the rear part of the fairing, see p. 22 (RE-
MOVING THE REAR PART OF THE FAIRING).
♦ Remove the battery as described on p. 75 (BATTERY
STORAGE).
♦ Detach the fuse strip (1) and the two dampers (2) and
(3) from their supports by passing them through the
slot as shown in the figure.
♦ ★Unscrew and remove the 4 screws (4).
♦ Unscrew and remove the filler cap (5).
♦ Remove the cap of the mixer oil tank (6).
♦ Disconnect the fuel breather pipe (7) from the fuel tank.
♦ Disconnect the drainage pipe (9) from the fuel bowl (8).
♦ Remove the fuel bowl (8).
NOTE Disconnect the electric connection of the central
control unit.
♦ Pass the cabling, complete with relay switches and
fuse block through the slot in the front of the saddle
support.
♦ Lift the front section of the saddle support (11), slide it
frontward and remove it.
NOTE When reassembling the saddle support (11),
before positioning it in its seat, refit the fuel bowl (8)
correctly and connect it to the drainage pipe (9).
♦ Screw on the filler cap (5) and return the mixer oil tank
cap (6) to its correct position.
Release 00 2003-02
7
4
3
11 6
9
1
Scarabeo 50 I.E.-50/100 4T
2
5
8
4
29