Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
RECHARGE AND GENERAL POWER SUPPLY CIRCUIT<br />
WIRING DIAGRAM<br />
Arrangement of the components: see p. 96 - 97.<br />
13) Fuses<br />
14) Battery<br />
18) Voltage regulator<br />
19) Generator<br />
29) Key switch<br />
TECHNICAL DATA<br />
Generator ............................................................... 140W<br />
Voltage regulator ................................................ 12 V a.c.<br />
Battery ................................................. 4 Ah - 12V sealed<br />
Fuse ......................................................................... 10 A<br />
CHECKING THE CHARGING SYSTEM<br />
– Start the engine.<br />
– Using the voltmeter function of the multimeter, connect<br />
the positive lead to the positive terminal of the battery,<br />
and the negative lead to the negative terminal of the<br />
battery.<br />
– At 6000 rpm voltage must be included between 13.5<br />
and 15 V.<br />
TROUBLESHOOTING<br />
A.INSUFFICIENT RECHARGE VOLTAGE<br />
– Check the fuse and, if necessary, replace it.<br />
– Check the cable connections on regulator, flywheel,<br />
battery and fuse.<br />
– Check the battery (see below).<br />
– Check the generator (see below).<br />
80<br />
G<br />
Ar<br />
19<br />
V<br />
Ar/Bi<br />
B.EXCESSIVE RECHARGE VOLTAGE<br />
– Check the voltage regulator.<br />
– Check the cable connections.<br />
C.IF NO VOLTAGE REACHES THE LOADS UNDER<br />
DIRECT CURRENT (green/red cables)<br />
– Check the fuse and if necessary replace it.<br />
– Check the ground connections on regulator, flywheel,<br />
B<br />
18<br />
Ar<br />
14<br />
Release 00 2003-02<br />
10 A<br />
R/N<br />
13<br />
7,5 A<br />
Ar<br />
13<br />
R/N<br />
Ar<br />
29<br />
V/R<br />
INJECTION RELAY<br />
ELECTRICAL FUNCTIONS<br />
UNDER D.C.<br />
LIGHTS<br />
<strong>Scarabeo</strong> 50 I.E.-50/100 <strong>4T</strong><br />
INJECTION<br />
battery and fuse.<br />
– Check the battery (see below).<br />
– Check the generator (see below).<br />
– Check the ignition switch (see p. 96) and its connections.<br />
D.IF THE SYSTEM FUNCTIONS IRREGULARLY<br />
– Check the earth connections.<br />
TEST DATA<br />
GENERATOR<br />
– Disconnect the two-way connector from the generator.<br />
– Start the engine and bring it to 6000 rpm.<br />
– Using the alternating current function of the multimeter,<br />
measure the voltage between:<br />
• orange cable and generator earth = value over 41.2<br />
V.<br />
• yellow cable and generator earth = value over 35V.<br />
– Using the alternating current ammeter function of the<br />
multimeter, measure the current between:<br />
• orange cable and generator earth = value 8 - 10 A.<br />
• yellow cable and generator earth = value 8 -10 A.<br />
BATTERY<br />
– No-load voltage 12.5 ± 1V.<br />
– Make sure that there are no signs of sulphation.<br />
Replace if necessary.