Field Logger 512 k User Manual - Temperatur-Shop

If the RS485 interface was configured as Modbus master, the following screen will be displayed. You should set up a tag
(name - maximum of 16 characters), unique for each channel, and optionally a unit (maximum of 10 characters) for the
reading value.
In addition, for each channel, you should set up which network slave is to be read, what Modbus command sholud be
used and what is the initial register to be read from the slave. In the current version, the number of registers is always
"1", which means that you can not do block reading.
An error value must also be configured. This value is shown on the channel when there is a problem, for example, a
communication error with the slave.
At the end of the channel configuration, you must click on the “Add” button in order to enter the channel in the list to the
left. If you want to remove a channel from the list, you must select it from the list and click on "Remove".
Remote Channels - Setting up a channel
NOVUS AUTOMATION www.bubthermo.de www.fieldlogger.net 39/84 40