UBI EasyCoder 401 ? Technical Manual CONTENTS

UBI EasyCoder 401 – Technical Manual
INSTALLATION, cont'd.
Computer Connection
WARNING!
When connecting printer and host,
the power should be off!
UBI Standard Cables
RS 232C Cables:
Printer to IBM-AT 1-975581-05
Printer to IBM-XT/PS2 1-975580-05
Printer to Mac 1-010007-00
DB-25 Gender Changer
Centronics Cable:
1-010008-00
DB-25/Centronics 1-010001-00
EasyCoder 401 is always fitted with one communication port
("uart1:") for RS 232C on the rear plate.
As an option, this communication port can be reconfigured for
either RS 422 or 20 mA Current Loop after additional circuits have
been fitted on the CPU board, see chapter “Interfaces”.
The EasyCoder 401 can also be fitted with an optional parallel
interface board, e.g. for use with the UBI Windows Driver.
With the exception of the UBI Macintosh Driver kit, no communication
cable is provided unless ordered separately. Refer to the
chapter “Interfaces” for cable configuration descriptions.
Refer to the manual of the host computer or terminal for information
on how to connect the other end of the communication cable.
0
230V
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
MADE IN SWEDEN
Hints:
• For UBI LabelShop, UBI Direct Protocol or UBI Fingerprint programming,
use the "uart1:" serial RS 232C communication channel.
• For UBI Windows Driver, use the "centronics:" parallel communication
channel.
• For the UBI Macintosh Driver, use the "uart1:" serial communication
channel. A special cable with gender changer is included in the driver kit.
• UBI's standard communication cables and adapters makes it possible to
connect the printer directly to the serial or parallel port of an IBM AT, XT or
PS-2 personal computer, or the serial port of an Apple Macintosh computer.
TA
Parallel Port
36-p female Centronics
(option)
Serial RS 232C Port
DB25 male
10