UBI EasyCoder 401 ? Technical Manual CONTENTS

UBI EasyCoder 401 – Technical Manual
STARTING UP, cont'd.
Messages at Startup
The type of startup file running in the printer is indicated by the
message shown in the display window directly after power up.
A. UBI Shell Startup Program (standard in EasyCoder 401):
PRINT=UBI SHELL or ENTER=UBI SHELL
5 sec. v.4.0 5 sec. v.4.0
4 sec. v.4.0 4 sec. v.4.0
3 sec. v.4.0 3 sec. v.4.0
2 sec. v.4.0 2 sec. v.4.0
1 sec. v.4.0 1 sec. v.4.0
Refer to the UBI Shell Standard Startup Manual. The digits in the
lower right corner of the display indicate the version of UBI Shell.
B. No Startup File (non-standard EasyCoder 401):
UBI Fingerprint
6.0
Refer to the documentation of the corresponding version of UBI
Fingerprint for further information.
C. Custom-made Application Program (non-standard EasyCoder 401):
Any other display message than those illustrated above indicate that
the printer is running some custom-made, non-standard application
program or that some error has occurred.
12